Raymarine Autohelm ST3000 User manual

ST3000 Wheel Pilot Quick Reference Guide
Auto mode
Track mode Wind Vane mode
Autopilot displays
or
1 sec
and and
and
and
and and
Basic operation
Entering Track mode (from Auto or Wind Vane mode)
Making course changes
Course
changes
to port
Course
changes to
starboard
Entering Wind Vane mode
1˚
10˚
Switching lighting on/off
(from Standby mode only)
Switching AutoSeastate on/off
(from Auto/Track/Wind Vane modes)
to accept new heading
to enter Track mode
and
Wait 10 sec to return to previous mode. D5659-1
then
then
Returning to Standby (Disengaging the autopilot)
Entering Auto mode (Engaging the autopilot)
Returning to previous locked heading
again to accept heading
Press to
switch between:
Press to
switch between:
OFF
ON
OFF
ON
Using AutoTack
AutoTack
to port
(100˚)
AutoTack to
starboard
(100˚)
Press STANDBY or AUTO to exit Wind Vane mode.
Press STANDBY or
AUTO to exit.
+
+
86005_2.book Page 1 Monday, July 9, 2001 11:58 AM

Document number: 86005-2 (use with handbook: 81194)
Date: June 2001
ST3000 Wheel Pilot Quick Reference Guide
Enter compass calibration
1
Turn boat in slow circles
2
Autopilot displays amount of deviation detected
3
Align the autopilot heading
4
Save changes
5
1 sec
1 sec
D5660-1
Turn the boat in slow circles so:
•boat's speed stays below 2 knots
•each circle takes at least 3 minutes
To:
•save deviation correction
•save heading alignment
•return to STANDBY mode
To:
•quit compass calibration
without saving
Keep turning the boat until the display alternates between:
•autopilot heading
•deviation detected
Start turning boat
(see 2 below)
Autopilot headingAutopilot heading
Steering
compass
Known
heading
or
or
Adjust the autopilot heading to match the boat's steering compass
Compass calibration
86005_2.book Page 2 Monday, July 9, 2001 11:58 AM