RBP RBP-1414B-RX3 User manual

RBP-1414B-RX3
Page 1of 2 10/18/17 (RA)
13000 TEMPLE AVE. CITY OF INDUSTRY, CA 91746 1-800-237-7506
HARDWARE INCLUDED
RECOMMENDED TOOLS
1
Driver Side RX3 Side Step
12
8mm x 24mm x 2mm Flat Washers
1
13mm Socket or Wrench
1
Passenger side RX3 Side Step
12
8mm Lock Washers
12
8-1.25mm x 30mm Hex Bolts
STEP 1 —Remove any old steps or factory installed “Rock Rails” and hardware from vehicle.
STEP 2 —Start installation on the driver/left front side of the vehicle. Locate and remove the (2) factory hex
bolts covering the mounting location on the body panel, (Figure 1). NOTE: Temporarily hold up in position the
driver side RX3 Step to help determine the correct mounting locations.
STEP 3 —Move along the body panel to the center and rear mounting locations and repeat Step 2, (Figure 2).
STEP 4 —Select the Driver side RX3 Step. Line up the welded Brackets on the Step with the threaded inserts on
the body panel. With assistance, use (6) 8mm Hex Bolts, (6) 8mm Lock Washers and (6) 8mm Flat Washers to
attach the (6) slots on the Brackets to the (6) threaded inserts, (Figures 3—6). Leave hardware loose.
Driver/left side
RX3 step
Passenger/right
side RX3 step
Front of
Vehicle
2010- 2017 4RUNNER RX3 SIDE STEPS

RBP-1414B-RX3
Page 2of 2 10/18/17 (RA)
13000 TEMPLE AVE. CITY OF INDUSTRY, CA 91746 1-800-237-7506
STEP 5 —Once the step is fully installed, adjust and align the RX3 Step to the vehicle and fully tighten
hardware.
STEP 6 —Repeat Steps 1—5to install the passenger side RX3 Step assembly.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Driver Side Installation Pictured
(Fig 1) Driver side Front Mounting Location
Front
(Fig 2) Driver side Rear Mounting Location
Rear
Front
(Fig 3) Driver side Front welded
Bracket illustrated with hardware
(Fig 4) Driver side Front
welded Bracket installed
(Fig 5) Driver side Center
welded Bracket installed
(Fig 6) Driver side Rear welded
Bracket installed
Front
Front
(2) 8mm Hex Bolts
(2) 8mm Lock Washers
(2) 8mm Flat Washers
Rear
Remove (2) factory hex bolts
Remove (2) factory hex bolts
(2) 8mm Hex Bolts
(2) 8mm Lock Washers
(2) 8mm Flat Washers