STEP 1 —Remove any old steps or factory installed “Rock Rails” and hardware from vehicle.
STEP 2 —Start installation on the passenger/right front side of the vehicle. Locate and remove the (2) factory
hex bolts covering the mounting location on the body panel, (Figure 1). NOTE: Temporarily hold up in position
the passenger side RX7 Step to help determine the correct mounting locations.
STEP 3 —Move along the body panel to the center and rear mounting locations and repeat Step 2, (Figure 2).
STEP 4 —Select the Passenger side RX7 Step. Line up the welded Brackets on the Step with the threaded
inserts on the body panel. With assistance, use (6) 8mm Hex Bolts, (6) 8mm Lock Washers and (6) 8mm Flat
Washers to attach the (6) slots on the Brackets to the (6) threaded inserts, (Figures 3—6). Do not tighten.
STEP 5 —Once the step is fully installed, adjust and align the RX7 Step to the vehicle and fully tighten
hardware.
STEP 6 —Repeat Steps 1—5to install the driver side RX7 Step assembly.