RealFlame 310 Product manual

Model 310 2 Can Log Set
Instructions and warnings for use
WARNINGS
- Log set can be used indoors or outdoors, there is no need for ventilation.
- Use extreme caution while burning. Some surfaces become extremely hot during use.
- Follow all instructions included with gel fuel before use.
- Before using log set, be sure you have read and understand the step-by-step instructions.
- After several burns, soot may develop on the plate. Clean with warm soapy water.
- During the initial burn you may experience a slight odor. Odor is temporary and will be absent on following burns.
!!!
Rev. 050108
Welcome to the Real Flame family of gel fuel
products. If you have questions please call
customer service at 1-800-654-1704 or log
on to www.REALFLAME.com.
1. Log set is designed to be used with REAL FLAME gel fuel only. Do not use with any other gel fuel or any other
flammable liquid or gel.
2. Read entire label and instructions before using REAL FLAME gel fuel.
3. Never leave a burning fire unattended, especially around children or pets.
4. When operating log set be sure that the material surrounding the log set is non-combustible and it is clear and free of all
flammable materials.
5. Never touch lantern during or after burning gel fuel. Base and glass surround may be extremely HOT. Allow base, glass and
gel fuel cans to cool for 60 minutes before touching.
6. Keep away from children and pets. Fireplace is not to be operated by children.
7. Do not attempt to refill or replace gel can while unit is burning.
8. Make sure log set and gel fuel are burned on a flat and level surface.
9. Do not alter log set in any matter.
10. Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this product.
11. Do not wear flammable or loose clothing when using the fireplace.
12. Do not attempt to move or store the log set until 60 minutes after gel fuel cans have been extinguished.
13. Do not lean over log set when lighting or when in use.
14. Do not burn gel fuel outside designated burn area.
15. In case of an emergency use a CO2 extinguisher to extinguish the fire.
16. Death, serious injury or damage to property may occur if the above is not followed exactly.
17. If for any reason you cannot follow these warnings please call us at 1-800-654-1704.
NOTICE: Buyer assumes all responsibility for safety and use that is not
in accordance with instructions and warnings.
Using your Log Set
®

310 2-Can Log Set Instructions ®
Parts List
Number Description Part Number Quantity
1 Concrete Base 311 1
2 Top Log 312 1
3 Plate 313 1
4 1” Philips Head Bolt 9742 1
5 5/16” Washers 10-3 5
6 Lava Rock 4089 1 Bag
Step One
Figure 1
Attach the Plate (3) to the Top Log (2)
with a bolt and washers in the order
shown.
Order from top to bottom should be
Top Log (2), 2 washers, Plate (3), 1
washer, bolt.
3
2

Step Two
Figure 2
After opening Real Flame gel fuel cans,
place one can into each recession in the
base.
Place the Top Log with Plate attached onto
the base. Plate should be in contact with
the gel fuel cans with tabs on the inside of
the can opening.
If the plate is not sitting on the cans, add
another washer between the Top Log and
the Plate. Repeat as necessary to acheive
the correct fit.
Step Three
Figure 3
Lite the gel fuel with an extended lighter
or match.
Do not touch the log or the plate while
burning gel fuel. It will be extremely
HOT!
Figure 2
Figure 3