RealFlame Ledgestone T0027 User manual

Lot: _______________
P.O. _______________
T0027
Ledgestone Propane Tank Cover Owner’s Manual
!
Warning:
For Outdoor Use Only.
If stored indoors, detach
and leave cylinder outdoors.
!
Warning:
If the information in this manual is not
followed exactly, a fire or explosion
may result causing property damage,
personal injury or loss of life.
Installation and service must be
performed by a qualified installer,
service agency or gas supplier.
Improper installation, adjustment,
alteration, service or maintenance can
cause injury or property damage.
Read the installation, operation
and maintenance instructions
thoroughly before installing or
servicing this equipment.
Save these instructions for future
reference. If you are assembling
this unit for someone else, give
this manual to him or her to read
and save for future reference.
!
!
!
!
!
!
!
DANGER
IMPORTANT
If
1. Shut off gas to the appliance.
2. Exnguish any open flame.
3. If odor connues, keep away
you smell gas:
from the appliance and
immediately call your gas
supplier or fire department.
!WARNING
Do not
Use Liquefied Petroleum Gas (LP-Gas) only!
flammable vapors and liquids in the
store or use gasoline or other
vicinity of this or any other appliance.
An LP-cylinder not connected for use
should not be stored in the vicinity of
this or any other appliance.
READ BEFORE USE
SAVE THESE
INSTRUCTIONS
Real Flame Customer Service: 1-800-654-1704
Propane Cylinders Sold Separately
In Canada: 1-800-363-6443

3
4
7
8
Parts List
Assembly Instructions
Care and Cleaning
Warranty
Table of Contents
2

Parts List
3
1
2
3
1Ledgestone Propane Tank Cover N/A 1
Tank Holder Base 06700002 1
Feet 06000003 4
2
3

1
Assembly Instructions
4
Feed the propane tank end connection of the hose up through the bottom of the
Tank Holder Base (2). Be sure to not feed the hose through the center of the base
(this is where the propane tank will be seated).
2Place the propane tank in the base.
To Propane
Fireplace
2
To Propane
Fireplace

5
3
Place the propane tank in the base and secure the tank by tightening the screw at the
bottom of the base.
4
Connecting the LP Gas Tank
Check to make sure there is no debris in
the head of the LP gas tank or in the
head of the regulator valve. Make sure
you check the burner and burner ports
as well.
Connect gas line to tank by turning knob
clockwise. Hand tighten only.