RealFlame 8900 User manual

Fireplace Model # 8900
Instruction Manual
®

Rev. 06/04/07
Using your Fireplace
- Follow all instructions included with gel fuel before use.
- Before using Fireplace make sure you have read and understand the step-by-step instructions.
- During the initial burn you may experience a slight odor. This odor is temporary and will be absent on following burns.
Instructions and warnings for use
Welcome to the Real Flame® family of gel fuel products. If you have any questions
please call customer service at 1-800-654-1704 or log on to www.REALFLAME.com.
WARNINGS !!
NOTICE: Buyer assumes all responsibility for safety and use that is not
in accordance with instructions and warnings.
1. Fireplace is designed to be used with Real Flame®gel fuel only. Do not use with any other gel fuel or any other flammable
liquid or gel.
2. Read entire label and instructions before using Real Flame gel fuel.
3. Make sure fireplace is set on a flat, level and stable surface. Keep fireplace stable at all times.
4. Make sure fireplace and gel fuel are burned on a flat and level surface.
5. Never leave a burning fire unattended, especially around children or pets.
6. Fireplace is not to be operated by children. Keep away from children and pets.
7. Exercise the same precautions as you would with any open fire.
8. When in use some surfaces will be hot, use caution.
9. Never touch logs, gel fuel cans or any other metal surfaces during or immediately after burning gel fuel. They will be extremely
 HOT. Allow them to cool for 60 minutes before touching.
10. Do not burn more than three cans of fuel at once.
11. Do not place more than 15 lbs. of weight on the top of the fireplace at anytime.
12. Do not alter fireplace, metal firebox or log set in any manner.
13. Keep fireplace and gel fuel cans away from flammable materials at all times.
14. Do not store or use gasoline or any other flammable vapors, liquids, or materials in the vicinity of fireplace and gel fuel.
15. Do not wear flammable or loose clothing when operating the fireplace.
16. Do not move fireplace while in use. Do not attempt to move or store the fireplace until 60 minutes after gel fuel cans have
been extinguished.
17. Do not burn trash, paper, or wood in the fireplace. Burn only Real Flame®gel fuel in the fireplace.
18. Do not burn gel fuel outside designated burn areas on the metal grate.
19. Do not put fireplace in an area with lots of traffic, such as a hallway or entryway.
20. In case of an emergency use a CO2 extinguisher to extinguish the fire.
21. Death, serious injury or damage to property may occur if the warnings above are not followed.
22. If for any reason you cannot follow these warnings please call us at 1-800-654-1704.
®
®
STOP!
If parts are missing or damaged, call 1-800-654-1704 for assistance

8900 Versailles Instructions
1
3
2
Figure 1
Parts List
Number Description Part Number Quantity
1Base8901 1
2Left Side Panel 8902 1
3Right Side Panel 8903 1
4Left Front Panel 8904 1
5RightFront Panel 8905 1
6Center Panel 8906 1
7Mantel Top 8907 1
8Left Facing 8908 1
9Right Facing 8909 1
10 Lower Facing 8910 1
11 Firebox Support 8911 1
Not shown
Firebox Clips 1075 2
Screws 9716 Bag
Step One
Figure 1
- Set Base (1) on a flat surface.
- Using tongue and groove attach Right Side
Panel (3) and Right Front Panel (5) together
with three screws through holes in each
mounting block.
- Repeat with Left Side Panel (2) and Left
Front Panel (4)
- Place assembled right Panels on the outside of
the mounting blocks on Base and attach with
two screws through holes in each mounting
block. Right Side Panel (3) should be flush with
the rear edge of the base.
- Repeat using assembled Left Panels.
Before assembly, locate instructions and hardware.
Take out all parts and compare them to the
photograph and the assembly illustrations. Be sure
you have all parts identified.
Check for screws that are wrapped in the
packaging to be sure you don't discard them. You
may have extra screws.
A helping hand is always good. Assemble fireplace
with an adult assistant if possible.
The cement log is heavy. Put the fireplace in the
desired location before inserting cement log.
Use caution not to over tighten screws.
4
5

6
9
8
10
Figure 2
Figure 3
Step Two
Figure 2
- Attach theRight Firebox Trim (9) to the rear of
the Right Front Panel through the three holes in
Trim.
- Attach the Right Firebox Trim (9) to the Base
(1) with one screw through mounting block on
Base.
- Repeat both steps with Left Firebox Trim (8).
- Place Lower Facing (10) on base between
Right and Left Facing. Attach with four screws
through mounting blocks.
- Using tongue and groove slide the Center Panel
(6) between Right and Left Side Panels. Attach
with two screws through each mounting block.
Step Three
Figure 3
- With support block facing the front of the unit,
first fit Firebox Support (11) into hole in Right
Side Panel.
- Next, slide opposite end into the groove in Left
Side panel. Make sure support is firmly set in
place.
11

7
You are now ready for the firebox
installation. Please refer to the instructions
that are included with
y
our firebox.
Figure 4
Step Four
Figure 4
- Set Mantel Top (7) on top of unit so trim
hangs over the front and sides.
- First attach through the holes in the center
panel and then through the holes in each side
panel.