
8
I I. OPERATING THE APPLIANCE
Use the thermopot
1.
Place the appliance to the dry, solid, horizontal surface. Ensure
the escaping steam does not fall on wallpaper, decorative
coats, electric units and other items, which can be damaged
by steam and high temperature.
2. Raise the lid opening handle.
3. Pull the lid up.
4. If you want to remove the lid, hold the lid opening handle up,
press the lid opening button and lift the lid angle wise. To put
the lid into place, follow the steps described in reverse order.
5.
Pour water into the thermopot up to the FULL mark and close
the lid until it clicks.
CAUTION! To avoid appliance overheating, it is not recommended
to pour less than 0.5 liters of water. Rell water regularly to
prevent boiling over.
6.
Connect the appliance to the mains. Set the I/O power switch
on the back of the appliance to position I. The boil indicator
lights up and water starts to boil.
CAUTION! The thermopot is equipped with a shutoff system in
case if there is not enough water. If there is no or not enough
water in the appliance, it will turn off automatically.
Ways to supply water
After the boiling indicator (red one) goes out and the Keep Warm
indicator (green one) lights up, you can start pouring hot water
by placing a cup under the spout
1. Press the lock button to unlock the water supply (the in-
dicator will light up on the display).
2. Press and hold the “Налить” button until your cup is full.
3. Press the edge of the cup to the special button located near
the spout of the appliance. Hold it until your cup is full.
4. Press the pump until your cup is full.
In order to lock water supply using the pump, move the lock on
the lid of the appliance to the "Close" position. To lock the water
supply using the button next to the spout or the
“Налить”
button,
press the “Блокировка” button (the button indicator will go out,
the indicator will light up on the display).The locking function
protects your children and prevents accidental water pouring from
the thermopot.
Selecting the temperature
After the water boils, the thermopot will automatically switch to
temperature selection and maintenance mode. To set the desired
value, press the temperature setting button to select one of three
options: 65°C, 85°C, 98°C.
The selected temperature will appear on the display. When the
set temperature is reached, the availability indicator appears on
the display.
To reboil, press the corresponding button.
Timer adjustment
The on-delay timer will help you reduce energy costs.
1. To set the timer, press the “Таймер” button. The time value
on display will start blinking.