Renfert Vario 3 User manual

© Renfert GmbH TM 04/02
IndexIndex
Vario 3 waxing unit
No. 1456-0000 and 1456-1000
Areas of Caution
• Before switching on check that the unit's voltage matches the main power supply.
• Units with faulty leads or other defects should not be used.
• Do not cover the power units when in use.
• The compartments can get hot!
• Do not place anything on the lid as, depending on the set temperature, it can also get hot.
• Use only warm wax in the Vario 3.
• Do not apply a separate heat source (e.g. a flame).
• Never connect your Vario 3 waxing unit directly to the mains supply: Always use the transformer
supplied.
• Clean the compartments (refer to “Maintenance”) and half fill them with the desired Pico waxes.
Please note: Overfilling the compartments may cause the wax to spill over! Also, if the compart-
ments are too full, different temperature zone will be created in the wax, thus making waxing-up
more difficult.
• Unroll both cables of the power supply, in order to avoid an overheating in case of short circuit.
• The cables of the power supply must not be shortened.
Cleaning / Maintenance
Your Vario 3 waxing unit requires no maintenance. It should be cleaned from time to time. Use all the
wax in the compartment and then wipe it with a cloth or a cellulose duster. Set the unit to its lowest
temperature.You could get burned!

© Renfert GmbH TM 04/02
IndexIndex
Technical Specifications
Power supply waxing unit: 24 V ~ 2 A
Power supply transformer:
according to data transformer
Power consumption: 48 W
Temperature range: 50-100°C (+/- 1,5oC)
Time to max. temperature: approx. 20 mins.
Time to min. temperature: approx. 20 mins.
Dimensions (LxWxH): 105 mm x 170 mm x 65 mm
Troubleshooting Guide
Fault Cause Remedy
No display, • Interruption of • Check power
no function. power supply. supply and cables.
• Power adaptor • Refer to spare
defect. parts list.
• Power supply • Use appropriate
too low. power adaptor.
• Temperature • Replace.
fuse blown.
• Temperature • Unplug the power
fuse of the adaptor and cool
power supply it off for approx.
has released. 10 min., then
install again.
Unit functions, but • Thermo sensing • Replace.
no temperature. device defect.
• Heating element • Repair.
defect.