Renfert Vortex compact 3L User manual
Vortex compact 3L
Nr. 2924-5000 / -6000
Made in the EU
2012-06 21-6583 A // 302004253.B.1
Ideas for dental technology
#FEJFOVOHTBOMFJUVOH
*OTUSVDUJPONBOVBMݯ.PEFEtFNQMPJ
*TUSV[JPOJEݦVTPݯ*OTUSVDDJPOFTQBSBFMTFSWJDJP
ⓥུ䰌☦ݯᏮ⊉䫄☦✐ݯ瑪穧瓢湃瓚
ⳃ㋝崲㈓㊨医ⳃ䐁䔻曇䘣Ⲫ䕈䕖咠猉偨ⰦႦ
ᄴᅧᄟᅨ历㈓Ⴅ朙渼䐁აᄎჹ曡嶊ჴᅍᅵᄵᅤᅰჵ曡嶊ჴ㖧历㈓ᅦᅖᅨჱ栴津მᄒწᄄჟႦ
饝逭鰽螙錅麝黱鷽鸑銐蒱蒱錅麅鷁蒱蒱鷙鄆ꦑ鱑ꫝ饝誙鰵鸉餶襉襥
1. 1.
2.2.
6
32
1
2
3
4
5
6
7
2
8
9
1
1. 1.
2.
4 5
7 8 9
10 11 12
3
14 15
16 17 17
13
18
EN- 1 -
Vortex compact 3L
No. 2924-5000 / -6000
Introduction
our mobile lab dust extractor .
Before putting the device into operation,
please read these operating instructions
thoroughly and keep them close at hand for
future reference.
Observe the danger advices and warnings
as laid out in the „Operator‘s notes“.
Use these operating instructions to instruct
the operator in the applicable range of ope-
ration, the potential risks when operating
the device and how to actually operate the
device.
For further information, see section
Symbols
Danger
Immediate risk of injury.
Electric power
Risk of electric shock.
Attention
Failure to observe this note can result in
damage to the unit.
Note
Useful practical information that helps you
handle and operate the unit.
LThe unit corresponds to the dust category
L according to IEC/EN 60335-2-69. Suitable
for dust with a MAK (Occupational Exposu-
re Limit) value of > 1 mg/m³.
The extracted dust may contain health
endangering substances.
Always ensure adequate protection mea-
sures during disposal.
Read and comply with the operating
instructions.
ENGLISH
Contents
Introduction...................................................................................................... 1
Symbols............................................................................................................... 1
Operating Instructions
........................................................................................................ 2
............................................................ 2
................................................................................................. 2
........................................................................... 2
........................... 2
..................................................... 2
........................................................ 2
3.4.1 Extension cord......................................................................... 2
............................................................................. 2
............................................................................ 3
......................................................................... 3
... 3
................................................................. 3
3.9.1 To extract dry substances.................................................. 3
..................................................................... 3
.................................................................... 3
................................................................................... 3
.................................................................... 3
........................................................... 3
................................................. 4
...................................................................................... 4
............................................................................................ 4
.......................................................................... 4
7. Variants....................................................................................................... 4
......................................................................................... 4
9. Troubleshooting ............................................................................... 5
Operator‘s Notes
.............................................................................................. 6
................................................................................. 6
B. Danger Notices and Warnings....................................... 6
.......................................................................... 7
........................................................................................................ 7
..................................................................................................... 7
................................................. 7
.............................................................. 7
states.................................................................................................... 7
F. Technical Data................................................................................... 7
.................................................................... 7
H. Warranty.................................................................................................... 8
EN - 2 -
Operating Instructions
1. Unpack
-
ckaging.
-
tor (Fig. 4).
(see Fig. 1, 2, 3)
2 Power socket
4 Hose connector
5 Dust retainer
3. Operation
Dry dust
- dust bag
-
wet dust
-
water
-
-
3.1 Insert Dust bag
-
tor (Fig. 4).
Place Dust bag in dust retainer and thoroughly
disposal bag
It is recommended to use a disposal bag
-
sure of dust free disposal of the extracted
material.
extractor (Fig. 4).
retainer (Fig. 8).
walls and bottom of the dust retainer.
-
3.3 Connect dust generator
Slot hose into hose connector (Fig. 12).
necessary.
3.4 Connect power source
Check that the rated operating voltage spe-
mains voltage.
Check that the dust extractor is off.
contact mains outlet.
Connect unit to a fault current circuit breaker.
of mains leads.
3.4.1 EXTENSION CORD
cord has the correct minimum cross section:
Cord length Cross-section
1.5 mm²
2.5 mm²
2.5 mm²
3.5 Manual control
Switch extractor on and off on main
switch (3, Fig.
2)
Switch setting Function
OFF
I ON (manual mode)
auto automatic mode
EN- 3 -
3.6 Suction control
switch (3, Fig. 2).
-
3.7 Automatic mode
turns the extractor on or off. Intended use includes
Observe the maximum tolerable power
input of the electrical appliance to be con-
nected: See section „Technical Data“.
Before setting the selector to „auto“ check
that the connected electrical appliance is
turned off.
Turn off extractor.
and extractor.
extractor (Fig. 13).
The extractor will start as you turn on the connected
When you turn off the electrical appliance,
the extractor will trail off for a couple of
seconds to ensure that any dust in the hose
is completely blown into the dust retainer.
Filter-System“
Press „Free-Filter-System“ button three times
(Fig. 14).
In doing so, the dust from the inside surface will also
3.9 Extraction methods
Here is some general information.
3.9.1 TOEXTRACT DRY SUBSTANCES
When extracting dry materials it is essential to use
the extracted material.
dry substances are extracted afterwards. Before you
start extracting dry substances you should therefore
dry one.
3.9.2 TOEXTRACT LIQUIDS
Immediately interrupt the work in progress
and empty the dust retainer when you noti-
ce that foam is beginning to form.
4. Cleaning / Servicing
4.1 Check seals
-
A dirty or damaged dust retainer rim or seal
will reduce the suction power.
4.2 Replace Dust bag
-
tor (Fig. 4).
regulations.
Clean dust retainer.
4.3 Replace disposal bag
-
tor (Fig. 4).
-
tor.
regulations.
-
(Fig. 7).
retainer (Fig. 8).
EN - 4 -
-
!-
"
extractor (Fig. 4).
(Fig. 15).
necessary.
statutory regulations.
!
socket.
-
tor (Fig. 4)
(Fig.18).
5. Spare Parts
this manual.
6. Standard Delivery
1 Renfert
1 Suction hose assembly, 3m
7. Variants
8. Accessories
EN- 5 -
9. Troubleshooting
Problem Cause Remedy
Motor won‘t run Fuse blown in mains socket.
Turn off dust extractor and allow to cool down
Team if the extractor still fails to restart.
If the extractor is to be situated in a base cabi-
Motor won‘t run in
Auto mode
check if connector is tight.
Reduced suction
power
Suction control turned down
too low.
Suction hose/nozzle clogged.
Seal between container and
«Free-Filter-System» mecha-
due to coiled cable.
Set suction control as described in “Suction
Clean suction hose/nozzle.
bag.
is not actuated.
Extractor won’t pick
up wet substance
Dust retainer full.
EN - 6 -
Operator‘s Notes
Use these operating instructions to instruct
the operator in the applicable range of ope-
ration, the potential risks when operating
the device and how to actually operate the
device.
A.Application
A.1 Intended use
Use the unit for extracting dry, non-combustible dust
The unit is suitable for commercial use, e.g. in dental
labs.
When used properly, the safety vacuum
cleaner described in this manual is suitable
"#$$%$&'!%%($
and liquids. It is properly suited for the
vacuuming up and off of health endange-
'!%%($)*+#$
greater than 1 mg/m3 in accordance with
the dust class ‘L’ as per EN 60335-2-69.
In order to protect the health of persons
working in a dental laboratory, the law re-
quires that specialised dust extractors must
be used.
National regulations state the MAK value
- maximum concentration of suspended
particles in the air.
Find out about the legal national threshold
value and the type of dust generated in
your laboratory.
shall not be liable for any damages resulting from any
such other use.
B.Danger Notices and
Warnings
Top part of extractor housing contains live
(conducting) parts.
Contacting live parts will cause serious
injury or death.
Never spray top part of extractor housing
with water.
Risk of electric shock from a broken mains
lead.
Contacting a broken mains lead may cause
serious injury or death.
Avoid damaging the mains lead (e.g. by
pulling, squashing or driving over it).
Regularly check mains lead for damages
(e.g. rips, wear).
Before making further use of the unit, have
the Renfert Service Team or a skilled electri-
cian replace the broken mains lead.
The mains socket on the unit is only de-
Operating Instructions. Connecting other
devices may cause material damage.
Before connecting another device, turn off
both the dust extractor and the other de-
vice.
Read the operating instructions of the other
device and comply with the safety instruc-
tions contained in the document.
Risk of damage by non-compliant mains
voltages.
You may damage the unit if you connect
voltage.
Check the type plate to verify that your local
mains voltage matches the rated voltage.
Extracting liquids.
Immediately interrupt the work in progress
and empty the dust retainer when you
notice any foam beginning to form or liquid
escaping.
Regularly clean the built-in water level con-
#
Dangerous substances.
Extracting dangerous substances may cau-
se serious injury or death.
Do not extract any of the
following materials:
$ Health endangering dust with a MAK va-
lue of < 1 mg/m³,
$ hot materials (glowing cigarettes,
hot ash, etc.),
$ combustible, explosive, aggressive
liquids
(e.g. petrol, solvents, acids, caustic solu-
tions, etc.),
$ combustible, explosive dust (e.g. magne-
sium dust, aluminium dust, etc.).
Spare parts and accessories.
The use of other than OEM spare parts and
accessories may be an impediment to the
safety of the unit.
Use OEM spare parts and accessories sup-
plied by Renfert GmbH only.
Environmentally hazardous extraction sub-
stances.
Extracted substances may be a risk to the
environment.
Dispose of extracted material according to
local statutory regulations.
EN- 7 -
C.Admitted Persons
Unit
-
tion document to be taken by a skilled electrician only.
D.Repairs
-
alised dealers only.
E. Disposal
Immediately render the unit useless at the end of its
E.1 Disposal of consumables
E.2 Disposing of the unit
-
hazardous substances remaining in the unit.
E.3 Waste elimination notice for
EU member states
-
by throwing them into the unsorted household waste:
F. Technical Data
Mains lead: Length 7.5 m
Protection class I
Width 385 mm
G.Non-Liability Clause
damages and warranty if:
$ the product is used for any other than the inten-
document;
$ %!
instructions document;
$ product repairs are not made by specialised
dealers or if repairs are not made with OEM
spare parts supplied by Renfert;
$ continued use of the product is made despite
obviously reduced safety or obvious damages;
$ the product is exposed to mechanical impact or
if it is dropped.
EN - 8 -
&'
H.Warranty
Please note: The Vortex compact 3 L colle-
ctor motor is excluded from the guarantee
due to system related reasons. The motor is
subject to wear, depending upon frequency
of use and selected extraction level / power.
The service life varies greatly according to
demand. The average life span is approx.
800hrs.
3-year warranty
, assuming the unit is used as
intended.
natural wear and tear nor consumables (such as dust
-
instructions.
Satisfaction of claims under this warranty does not
Other manuals for Vortex compact 3L
3
Table of contents
Other Renfert Vacuum Cleaner manuals
Renfert
Renfert Silent User manual
Renfert
Renfert Dustex master plus User manual
Renfert
Renfert Silent V4 Operating and installation instructions
Renfert
Renfert Vortex compact 3L User manual
Renfert
Renfert Silent TS2921-1050 User manual
Renfert
Renfert SILENT compact Operating and installation instructions
Renfert
Renfert SILENT TC Operating and installation instructions
Renfert
Renfert Dustex master plus Installation guide
Renfert
Renfert Vortex compact 3L User manual
Renfert
Renfert Dustex master plus User manual
