resideo Honeywell Home PRO D6 User manual

D6 PRO Wi-FiDUCTLESS CONTROLLER Quick Guide
Warmer Cooler
Display sleep
The controller goes into Display sleep (the screen is dim) after 45 seconds of
inactivity. Press oto wake up the controller. This button push does not change
temperature or settings.
Room temperature
Any time the controller is not being interacted with, the current room temperature
is displayed on screen.
Viewing set temperature
Be sure the controller is not in Display sleep, then press +or -once to view the
current set temperature. The set temperature will “pulse” on screen. After a short
period of time the screen will change to display the room temperature.
Change temperature
1. Be sure the controller is not in Display sleep, then press +or -more than once
to change the set temperature so it is higher or lower in the current mode.
2. Stop pressing +or -when you reach the temperature you want.
3. The screen will pulse and then return to the room temperature display.

Symbol Mode
Heat mode - the ductless unit warms the space to the
temperature shown on the controller.
Cool mode - the ductless unit cools the space to the
temperature shown on the controller.
[screen is blank] Off mode - the ductless unit is turned off
Change mode
1. Be sure the controller is not in Display sleep, then press oto change the
system mode.
2. Stop pressing owhen you reach the mode you want.
The ductless unit will beep when it gets a command from the controller.
33-00388-05
Resideo Inc., 1985 Douglas Drive North,
Golden Valley, MN 55422
www.resideo.com 330038805 M.S. Rev. 0919 | Printed in United States
This product is manufactured by Resideo Technologies, Inc., Golden Valley, MN, 18006333991.
© Resideo Technologies, Inc. The Honeywell Home trademark is used under license from Honeywell
International Inc. All rights reserved.