ReSound Danalogic 6 6090 SP User manual

LEIÐBEININGAR UM NOTKUN
Danalogic 6 6090 SP
USER GUIDE

2
Congratulations on your new hearing instrument.
The Danalogic 6 6090 SP hearing instrument is a
completely new and advanced piece of technology
specifically designed for individuals with a severe
to profound hearing loss.
Please familiarize yourself with the contents of this
booklet in order to obtain the maximum benefit
from your new hearing instrument.
We congratulate you on your new instrument and
wish you a pleasant listening experience!
ReSound
Warning!
Hearing instruments, their component
parts and their batteries can be dangerous,
if swallowed, or improperly used.
Misuse of these instruments could result in
severe injury or death.
Danalogic 6 is a registered trademark of GN ReSound.
Contents
DANALOGIC66090SP..................4
BATTERY COMPARTMENT ................5
TURNING ON AND OFF ..................5
CHANGING BATTERY....................6
BATTERY WARNINGS ....................6
INSERTING THE INSTRUMENT..............7
REMOVING THE HEARING INSTRUMENT .....8
RECOGNIZING LEFT & RIGHT INSTRUMENT . . . 8
USER OPERATED CONTROLS ..............9
PROGRAM BUTTON....................10
T-PROGRAM ......................... 11
DAI CAPABILITY.......................12
TELEPHONE USE.......................13
DAILY MAINTENANCE . . . . . . . . . . . . 14-15
EAR MOULD .......................16-17
GENERAL PRECAUTIONS & INSTRUCTIONS 18-19
TROUBLESHOOTING GUIDE . . . . . . . . 20-21
REPAIRS & TECHNICAL DATA ............22
WARNINGS & NOTICES .................23
HELPFUL HINTS .......................24
3

4
5
Before starting to use your new hearing instrument
it is important that you spend some time learning
the user operated controls on the instrument.
Tone tube
Plastic tube
Ear mould
Microphone
Volume
Program
button
Battery door
Model 6090 SP
BATTERY COMPARTMENT
Before you start to use your hearing instrument,
open the swing-out battery door and make sure
there is a fresh battery in the compartment.
TURNING ON AND OFF
Turn your hearing instru-
ment on by closing the bat-
tery door. Turn your hearing
instrument off by pushing in
on the small knob located
on the battery door. This
will cause the battery door
to open.
The hearing instrument
will always be in program
1 when it is first turned
on. Additional information
about the programs can be
found on page 10.
Turning your hearing instrument off, when not in
use, will increase the battery life. Therefore, it is
recommended that you turn off your hearing in-
strument at night and open the battery door com-
pletely. It will also allow moisture in your hearing
instrument to evaporate and will increase the in-
strument’s lifespan.
off

6
7
INSERTING THE INSTRUMENT (with ear mould)
1) Hold the ear mould
between your thumb
and index finger and
position its sound out-
let in your ear canal
2) Slide the ear mould
all the way into your
ear with a gentle,
twisting movement
(insertion will be easier
if you gently pull your
ear up and back with
your other hand)
3) Turn the top-part of
the ear mould gently
backwards and for-
wards so that it tucks
behind the fold of skin
above your ear canal
4) Place the hearing in-
strument behind your ear
5) Move the ear mould up and down and press
gently to ensure it is positioned correctly in the
ear
6) When the ear mould and hearing instrument
are correctly positioned, and you have not al-
ready turned it on, switch on your instrument
by closing the battery door
Tip
Opening and closing your mouth can ease
insertion.
CHANGING THE BATTERY
Insert the new battery with the + side facing up
as shown on the side of the battery compartment.
Always remove the old battery before inserting a
new one.
6090 SP uses a type 675 zinc-air battery. A weak
battery will reduce the performance of the hearing
instrument.
BATTERY WARNINGS
Batteries contain dangerous substances and should
be disposed of carefully in the interest of your sa-
fety as well as for the environment.
Keep old batteries in a safe place and return them
to a hearing care professional for recycling. Do
NOT attempt to recharge batteries which are not
specifically designated rechargeable as they may
leak or explode.
Do NOT attempt to dispose of batteries by burning
them.
Keep batteries away from small children. If swal-
lowed, seek immediate medical attention.

8
9
REMOVING THE HEARING INSTRUMENT
To remove the hearing instrument, simply pull the
tube outward with your thumb and forefinger.
Consult your hearing care professional if you have
difficulty removing the hearing instrument.
RECOGNIZING LEFT AND RIGHT INSTRUMENT
If you have two hearing instruments, they may be
set differently for your right and left ears. Do not
switch the hearing instruments without consulting
your hearing care professional. If you detach the
ear moulds from the hearing instruments when
cleaning and/or storing them, verify that you have
connected the ear moulds to the appropriate hear-
ing instrument before fitting them to your ears.
To properly identify your left instrument from your
right you should see an indication just above the
Push button (see page 10), that designates
which ear the instrument is for. L is for Left and R
is for Right.
Left Right
USER-OPERATED CONTROLS
Volume control
Volume is adjusted by means of a conveniently lo-
cated rotary control marked from »1« (minimum
level) to »4« (maximum level).
Setting the volume
Your instrument has a volume control which al-
lows you to set and control the volume manually.
At the hearing instru-
ment fitting, your hear-
ing care practitioner will
choose an optimal vo-
lume setting for you.
Please note the setting
of that particular level.
Your volume control has
numbers on it to indicate how loud the hearing
instrument is set.
• If you prefer not to use the volume wheel your
hearing care professional can disable this fea-
ture.

10
11
T-PROGRAM
Your hearing instrument has a built in function
called the telecoil, which offers improved hearing
when used with a telecoil compatible telephone or
assistive listening device.
In this program, you typically will not be able to
hear any sound from the microphone, but will be
able to get direct sound input via a telecoil com-
patible telephone and/or a loop system, e.g. in
churches, theatres, etc., or at home. Your hearing
care professional has software that will enable
both the microphone and
the telecoil to be opera-
tional at the same time, if
so desired.
In order to activate the
telecoil, the telecoil pro-
gram must be selected
(typically available in pro-
gram 3).
PROGRAM BUTTON
Your hearing instrument has a push button
enabling you to use up to three different listen-
ing programs, each of them suitable for different
listening environments. If program 1 was enabled,
pressing the program
button will enable pro-
gram 2. If program 2
was enabled, pressing
the program button, will
enable program 3 etc.
An audible signal will be
heard after pressing the
program button. When
you press the program
button:
• One single beep will
be heard if the instru-
ment is in program 1
• Two beeps will be
heard if the instru-
ment is in program 2
• Three beeps will be
heard if the instrument is in program 3
When you close the battery door, the hearing
instrument will automatically turn on and the in-
strument will be set for program 1.
Press the program button to select a different
listening program.
Indication
Program button

12
13
DIRECT AUDIO INPUT(DAI) CAPABILITY
This hearing instrument
is equipped with direct
audio input (DAI) ca-
pability. DAI allows an
external sound source
to be connected di-
rectly to the hearing
aid via a DAI boot.
You will receive an improved signal, when using
DAI, because the sound is fed directly into the
hearing aid, bypassing some of the normal sour-
ces of noise. Some of the external devices that can
be connected to the DAI boot are a telephone, a
CD player, a computer etc… The DAI boot is an
optional accessory that can be purchased through
your hearing care professional.
• The sound source connects to your hearing in-
strument with a cable and an audio boot.
• The hearing instrument professional will set one
of your programs for direct audio input. To use
direct audio input (DAI), set the hearing instru-
ment to the DAI program (typically program 3).
• In this program, you will typically not hear any
sound from the microphone. Therefore, most
environmental sounds will not be heard in the
ear that is set to DAI. Your hearing care pro-
fessional has software to modify this program
to allow you to hear environmental sounds and
DAI simultaneously.
TELEPHONE USE
Using the telephone, while wearing your hearing
instrument, may require some practice. Many hear-
ing instruments will whistle, when the phone is
held up against them. To avoid this problem, the
6090 SP has an induction coil. By switching the
program button to the telecoil program (typically
program 3), the hearing instrument will only pick
up sounds coming from the telephone. You may
need to adjust the volume on the hearing instru-
ment to improve hearing understanding on the
telephone. The receiver of the telephone should
be placed as shown in the drawing below.
Program button
set for telecoil
DAI-boot

14
15
Protect your hearing instru-
ment from rough handling.
Avoid dropping it on hard
surfaces or floors.
Do not leave the instrument
near direct heat or sunlight.
Excessive heat can damage
the instrument or casing.
Use fresh batteries. Remove
the battery from the hearing
instrument when it is not in
use to prevent corrosion of
the battery contacts.
DAILY MAINTENANCE
Keep your hearing instrument clean. Wipe it with
a soft cloth or tissue after use to remove oil and
moisture. Remove any accumulated ear wax from
the sound outlet, for example with a small brush
as shown in the illustration, but never immerse the
instrument in water or other liquids since this may
cause permanent damage to the circuitry.
Keep your hearing instrument dry. If the instru-
ment has been exposed to high humidity or per-
spiration, enclose it in a sealed container (desicca-
tor) together with a drying agent overnight.
Consult your hearing care professional concerning
which drying agent to use.
Never attempt to dry it with a hair dryer, in the
microwave oven, etc.
Remove your hearing instrument before going
to sleep. In addition, open the battery
compartment to turn off the aid and allow it to
aerate.
The operating temperature range is from -10°C
(14°F) up to +50°C (122°F).

16
17
EAR MOULD
The ear mould feeds the amplified sounds from
the hearing instrument into the ear. It is impor-
tant that the ear mould fits correctly in your ear
and does not cause irritation or pain. If the ear
mould irritates your ear in any way and prevents
you from wearing your hearing instrument, please
contact your hearing care professional to have the
ear mould modified. You should never attempt to
modify the shape of the ear mould yourself.
The ear mould should be cleaned every day.
Remove the ear mould and the plastic tubing
from the hearing instrument before you clean
the ear mould. Lukewarm water should be
enough to clean grease and moisture off the
ear mould. Do not immerse the ear mould in
disinfectant liquids, such as alcohol, since this can
cause the tubing to dry out and crack. If
earwax is stuck in the tubing or ear mould,
use a syringe filled with lukewarm water to
“push” the wax out. The plastic tubing connecting
the ear mould to the hearing instrument should
be changed by hearing care professional if it be-
comes stiff or brittle.
Be sure to thoroughly dry the ear mould and it’s
tubing before connecting it to the hearing instru-
ment. Gently blowing in the tubing will remove
dry water trapped inside.
Ear mould Tube
Cleaning loop
Brush

18
19
GENERAL PRECAUTIONS
• Consult a physician if you find a foreign object
in your ear canal, if you experience skin irritation
or if excessive ear wax accumulates with the use
of the hearing instrument.
• Different types of radiation, e.g. from NMR or CT
scanners, may damage the hearing instrument.
Therefore, do not wear the hearing instrument
during these or other corresponding scan-
ning procedures. Other types of radiation
(burglary alarms, room surveillance systems,
radio equipment, mobile telephones, etc)
contain less energy and will not damage the
hearing instrument. They could, however, mo-
mentarily affect the sound quality, or cause the
hearing aids to emit an unexpected sound.
• Warning: Do not wear the hearing instrument
in mines or other explosive areas, unless those
areas are certified for hearing instrument use.
• Warning to hearing aid dispenser:
Special care should be exercised in selecting and
fitting a hearing aid whose maximum sound
pressure level exceeds 132 dB as measured with
an IEC 711 Ear simulator because there may be
a risk of impairing the remaining hearing of the
hearing aid user.
INSTRUCTIONS TO THE
HEARING CARE PROFESSIONAL
• Thorough medical/audiometric evaluation is
recommended prior to fitting a child with this
hearing instrument.
• Please instruct the end-user very carefully in how
to use and maintain the hearing instrument.
• Please store the hearing instrument in a dry
place at temperatures between 0°C (32°F) and
+40°C (104°F)
• Please dispose of the hearing instrument
and batteries in accordance with the proper
regulations