ReSound LiNX 3D 62 User manual

Quick guide
ReSound LiNX 3D™ 62

My hearing aid information
Product: ReSound LiNX 3D
Model: 62
Serial number (R):
_______________________________
Serial number (L):
_______________________________
Battery size: 13

Multi-function button (A):
MULTI-FUNCTION
BUTTON ACTION
RESULT
Short press UP
Short press DOWN
Long press UP
(3 seconds)
Long press DOWN
(3 seconds)
PROGRAM WHEN TO USE BEEPS
11
22
33
44
Programs:
(if set up by your hearing care professional)

Get to know your hearing aids
A. Multi-function button
B. Microphone
C. Receiver
A
D
C
B
F
E
View ReSound hearing aid tutorial videos at youtube.com/resoundus.
D. Dome
E. Battery door
F. Right/Left indicator

Getting started: On/O function
ON: Insert battery & completely
close battery door (E).
Program 1 will be active.
OFF: Open the battery door. Use
fingertip to pull it all the way.
What you need to know
ON
OFF
Inserting/Replacing the battery:
1. Open the battery door (E)
completely
by using
your fingertip.
2. Remove protective sticker from
battery and wait 2 minutes before
inserting the
battery into the
hearing aid to
allow full activation of the battery.
3. Insert the new battery
with the positive side
(flat side) in the
correct position, as shown.
4. Gently close the battery door.
If it doesn’t close easily, check to
see if the battery is upside down.

As needed: Change domes (D)
ReSound standard domes
1. Push the new dome over the
receiver.
2. Make sure that the new dome is
properly and securely maintained.
ReSound tulip domes
Tulip domes consist of two “petals”. It
is important that the largest petal is
the outermost petal. To ensure this:
1. Push the largest petal away from
the receiver tube using a finger.
This bends the petal forward.
2. Then push the largest “petal”
back, and it will be placed on top
of the smaller petal.
12
30
How to apply domes
It is recommended that your hearing care
professional change domes, as incorrect
dome replacement could result in injury.
ReSound standard domes
1. Push the new dome over the receiver.
2. Make sure that the new dome is
properly and securely mounted.
ReSound tulip domes
Tulip domes are mounted in a similar manner to standard domes, but a few extra steps are required. Tulip
domes consist of two “petals”. It is important to note that the largest petal is the outermost petal. To ensure
this:
1. Push the largest petal away from
the receiver tube using a finger. This
bends the petal forward.
2. Then push the largest “petal” back,
and it will be placed on top of the
smaller petal.
400344011-US-15.04-Rev.B.indd 30 20-05-2015 11:48:59
12
30
How to apply domes
It is recommended that your hearing care
professional change domes, as incorrect
dome replacement could result in injury.
ReSound standard domes
1. Push the new dome over the receiver.
2. Make sure that the new dome is
properly and securely mounted.
ReSound tulip domes
Tulip domes are mounted in a similar manner to standard domes, but a few extra steps are required. Tulip
domes consist of two “petals”. It is important to note that the largest petal is the outermost petal. To ensure
this:
1. Push the largest petal away from
the receiver tube using a finger. This
bends the petal forward.
2. Then push the largest “petal” back,
and it will be placed on top of the
smaller petal.
400344011-US-15.04-Rev.B.indd 30 20-05-2015 11:48:59
Daily: Clean your hearing aid.
Keep your hearing aids dry. Clean
the hearing aids using a soft cloth
or tissue.
Weekly: Clean the receiver tubes
and domes (D).
Use a soft cloth to clean the
receiver tube and dome on the
outside. Do not use water when
you are cleaning the receiver tubes.
Regular care & maintenance

Flight mode:
Some airlines prohibit the use of
wireless hearing aids (RF transmitters)
onboard. If required by your airline,
enable flight mode:
Disable wireless operation by
opening and closing the battery
compartment three times within ten
seconds (open-close, open-close,
open-close). Your instruments will
now be in flight mode.
The hearing aids must function in
flight mode for 10 seconds before
wireless operation can be re-enabled.
To re-enable wireless operation,
open and close the battery door one
time and wait thirty seconds before
opening the battery door again to
avoid accidentally entering flight
mode again.
Monthly: Change the wax guard or
see your hearing care professional.
For changing CeruSTOP™(white) wax
guards, complete the following steps:
1. Removal: Insert the removal side
of the wax guard tool into the
used wax guard so that the shaft
of the tool is touching the rim
of the wax guard. Slowly pull
the wax guard straight out.
removal side replacement side
Wax guard tool
2. Insertion: To insert the new wax
guard, gently press the
replacement side of the wax
guard tool straight into the
hole of the sound outlet until the
outer ring lies flush with the
outside of the receiver. Pull the
tool straight out. The new wax
guard will remain in place.

Beep/tone indicators
View ReSound hearing aid tutorial videos at youtube.com/resoundus.
BEEP/TONE INDICATION ACTION REQUIRED
Ding, ding, ding, dong Low battery Change battery
Ding (5 or 10) Hearing aid is starting up After dings cease,
hearing aid is turned on
Ding-ding,
ding-ding, etc.
Hearing aid is in flight mode Use in flight mode if desired,
or open-close battery door to
exit flight mode
Ripple tone Hearing aid is in streaming
mode
Use with wireless accessory
or press multi-function
button to exit streaming
mode

Troubleshooting
SYMPTOM CAUSE POSSIBLE REMEDY
No sound Battery door not closed
Dead battery
Battery door will not close
Blocked earmold or tube
Blocked wax guard
Turn on by closing the battery door (E)
Replace battery
Insert battery properly
Clean earmold or tube
Replace wax guard or consult your hearing care
professional
Not loud enough Blocked earmold or dome
Change in hearing, volume too low
Excessive ear wax
Clean earmold, replace dome, replace guard
Consult your hearing care professional
Consult your hearing care professional
Excessive
whistling/feedback
Incorrect earmold placement
Incorrect dome placement
Excessive ear wax
If none of the above
Re-insert earmold carefully
Re-insert dome (D)
Clean guard/consult your hearing care professional
Consult your hearing care professional
Wireless does not work Device may be in flight mode Open and close the battery compartment (E) once.
Wireless operation will reactivate ten seconds later.
If there are any other problems not mentioned in this guide, please contact ReSound or your hearing care professional.

For more information
400703011 Rev B 2017.02
ReSound Government Services
8001 E. Bloomington Freeway
Bloomington, MN 55420
1.800.392.9932
www.resound.com/veterans
Manufacturer according
to FDA:
ReSound North America
8001 E. Bloomington Freeway
Bloomington, MN 55420
1.888.735.4327
resound.com
Manufacturer according
to Health Canada:
ReSound Canada
303 Supertest Road
Toronto, Ontario M3J 2M4
1.888.737.6863
resound.com
Refer to the user guide included in
your hearing aid box.
Your hearing care professional can
be reached at:
View ReSound hearing aid tutorial
videos at youtube.com/resoundus.