REVELL PINEWOOD DERBY SKATEBOARD RACER SET User manual

INSTRUCTIONS
SKATEBOARD RACER SETSKATEBOARD RACER SETSKATEBOARD RACER SET
WWW.REVELL.COM
Contents
1. (1) Precut Wood Block
2. (4) Axles
3. (4) Wheels
4. (1) Stick-On Chassis Weight
5. (2) Decal Sheets
6. (1 each) Sandpaper 120 & 220 Grit
Read the entire instruction
sheet before beginning
assembly. Adult supervision
is required!
Assembly Instructions
1
1. Sand the body
using coarse (120
grit) sandpaper
rst, followed by
medium (220 grit)
paper. Optional:
to smooth out the
racer, use ner
paper.
2. Test t the
wheels and axles
for proper t.
Adjust as needed.
Set them aside for
later use.
Detail the Body
2
1. Clean all dust
from the racer.
Apply a thin coat of
paint1as evenly as
possible. When dry,
use ne sandpaper
to lightly scu
the paint. Apply
additional coats as
needed. Do not scu the nal coat.
2. Test t the
decals with the
backing still on.
Once you are sure
of their placement,
peel o the
backing and apply.
3. Use a foam
brush1to apply an
even layer of clear
coat.1 Extra layers
can be applied if
needed.
Installing the Wheels and Axles
3
1. Place a wheel on
each of the axles,
and press them
into the axle slots
on the bottom of
the racer.
2. Space each
wheel to have
a small gap.
Place the wheel
adjustment tool2
between the racer
and the wheel.
Move the axle and
wheel until the
tool ts snugly
between the inside of the wheel and the outside of the racer.
3. Place the kit
on a smooth, at
surface. Place a
wheel adjustment
tool2with the
camber check
section against the
face of the wheel.
Adjust each axle to
make the wheels
parallel to the edge of the adjustment tool.
WARNING:
CHOKING HAZARD — Small parts.
Not for children under 3 years of age.

PAGE 2
PAGE 2
WWW.REVELL.COM
RMXY9638
4. Apply graphite
powder3between
the inside of the
axle head and
outside of the
wheel. Slowly turn
the wheel and
shake the kit to
work the powder
into the wheel.
5. Apply graphite
powder3to the
inside of the wheel
where it makes
contact with the
body.
Weight the Car
4
1. Weigh the kit
with all the parts
installed. Use a
pair of pliers to
break off as many
sections of weight
as needed to
meet the 5 oz (141
gram) limit.
2. Attach the
weight to the
bottom of the kit
using the double
sided foam tape.
1 We recommend the Revell Paint & Brush Set (RMXY9630)
2 We recommend the Revell “Ocial Pinewood Derby® Wheel Adjustment Tool™” (RMXY9616)
3 We recommend Revell Graphite Powder (RMXY9614)
REVELL® INC. 1850 HOWARD ST., UNIT A, ELK GROVE VILLAGE, IL 60007 U.S.A.
MADE IN CHINA •ENTIRE CONTENTS © COPYRIGHT 2009