REVELL Fire Strike Pro User manual

Fire Strike Pro:
• Durable, painted scale body
• On/off switch and charging jack
• Counter-rotating rotor blades for stable flight
• Built-in LiPo (lithium-polymer) rechargeable flight battery
• Realistic left/right, forward/backward, and up/down scale-like
controls
Controller:
• Three-channel digital proportional control
• Trim dial to adjust flight orientation
• Charge status and power-on LEDs
• Easy and convenient battery recharging directly from the
controller
Main Features
Safety Precautions:
Warning: Do not modify or alter this unit. Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to operate the equipment.
Do not touch the spinning blades or fly over another person’s head. Adult supervision is required.
• Do not turn on the FIRE STRIKE PRO helicopter unless the
controller has been turned on first.
• Keep hands, hair and loose clothing away from the spinning
blades.
• Turn off the controller and FIRE STRIKE PRO when not in use.
• Remove the battery from the controller when not in use.
• Parental guidance is recommended while flying.
• Always keep your FIRE STRIKE PRO in sight while flying.
• For the best performance, use new alkaline batteries in the
controller.
• Replace the batteries in the controller with new ones as soon
as any function becomes diminished.
• Keep these instructions for future reference.
• Follow the operating instructions exactly.
• Your controller’s built-in charger is made specifically for the
rechargeable FIRE STRIKE PRO LiPo battery. Do not use it to
charge any other battery.
WARNING:
CHOKING HAZARD — Small parts.
Not for children under 3 years of age.
“This product is in compliance with the
essential requirements and other relevant
provisions of Directive 1999/5/EC.”
Do not touch the spinning blades
or fly over another person’s head.
Adult supervision is required.
This device complies with Part 15 of
the FCC rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device
must accept any interference
received, including interference that
may cause undesired operation.
FCC REQUIREMENT
Care and Maintenance:
• Always remove the batteries from the controller when it is not
being used for a long period of time.
• Wipe the toy gently with a clean, damp cloth.
• Keep the toy away from direct heat.
• Do not submerge the toy into water.This could damage the
electronic assemblies.
Adult supervision is required.
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Battery Cautions:
• Non-rechargeable batteries are not to be recharged.
• If the controller uses rechargeable batteries, remove them
before recharging.
• Rechargeable batteries should be recharged only by an adult.
• Do not power the controller by mixing different types of
batteries, or old and new batteries.
• Use only batteries of the same or equivalent type as those
recommended.
• Install batteries following the correct polarity.
• Remove exhausted batteries from the controller.
• Do not short-circuit the supply terminals.
The FIRE STRIKE PRO is equipped with a rechargeable LiPo
battery. Please pay attention to the following cautions for safe
use:
• Do not dispose of the battery into fire or heat.
• Do not use or leave the battery near a heat source, such as fire or
a heater.
• Do not strike the battery or throw it against a hard surface.
• Do not immerse the battery into water. Keep the battery cool and dry.
• When recharging the battery, use only the charger designed for that
purpose.
• Do not over-discharge the battery.
• Do not connect the battery to an electrical outlet.
• Do not directly solder the battery or pierce it with a nail or other
sharp object.
• Do not transport or store the battery together with metal objects such
as necklaces, hairpins, etc.
• Do not disassemble or alter the battery.
• Charge the battery every six months.
• Turn off your equipment power switch after use.
• Recycle used batteries after covering the battery terminals with
insulation tape or inserting the battery into an individual polybag.
Note:
• Parental guidance is recommended when installing or replacing
batteries.
• Static electricity may cause the toy to malfunction, requiring you to
turn it off and back on before flying again.
Note Specifically for Adults:
• Regularly examine all parts of the toy for damage. If any is found,
do not use the toy again until the damage has been repaired.
• This toy is not intended for children under 8 years old.
• This toy must be used only with the recommended charger.
• Do not try to charge other batteries with the controller’s charger.
CAUTION: Changes or modifications to this product not expressly
approved by the party responsible for compliance may void the user’s
authority to operate the equipment.
Contents
Instruction Manual
page 1page 4
Battery Requirement for FIRE STRIKE PRO:
Requires: 3.7V LiPo Rechargeable Battery Pack (included and
installed)
Battery Requirements for Controller:
Rating: DC 9V
Requires: 6 x 1.5V “AA” size batteries (not included)
Safety Tips
• Read through the entire instruction manual before flying your FIRE STRIKE PRO.
• This product should be flown only indoors.
• Make sure that you and other people stay 3 to 6 feet (or 1 to 2 meters) away from the FIRE STRIKE
PRO while you begin flight.
• Always keep your eye on the flying toy to prevent it from flying, landing, or crashing on or near your
head or body, or on other people.
• Never disassemble or attempt to modify the FIRE STRIKE PRO. You could damage the product and
create the potential for damage or injury.
• Never put your hands or face close to rotating parts. Doing so risks injury. Never operate the FIRE
STRIKE PRO while sitting on the floor or on a chair — always fly from a position that lets you get out
of the way quickly if necessary.
• Always switch off both the FIRE STRIKE PRO and the controller when you leave the controller unat-
tended. If the power switch is left on, unintended stick operation might occur (for example, if the
controller falls face-forward onto the floor).
• Due to the dangers of the rotating parts no one under the age of eight should be allowed to operate
the FIRE STRIKE PRO.
• Never use parts that are damaged.
Operating Tips
• Always move the controller’s throttle stick to the down position after a crash.
• Do not fly in direct sunlight or very bright lighting — these can affect the control system of your toy.
• Do not cover the infrared signal emitter of the controller. If you do, no signals can be sent to your FIRE
STRIKE PRO.
• Do not place any other labels or stickers onto the FIRE STRIKE PRO. These will interfere with its ability
to receive the infrared signal.
• Two FIRE STRIKE PRO models cannot be flown on the same radio band.
Control Tips
• When moving the sticks of the controller, avoid pushing them immediately to the extreme positions.
They should be moved gradually like steering a bicycle, not sharply like operating computer game
joysticks.
• After completing the trimming procedure, beginner pilots should focus exclusively on mastering the
throttle stick first. Even if the FIRE STRIKE PRO turns around a bit by itself, there is no need to keep it
flying straight — just learn how to maintain a constant altitude of about 3 feet (or 1 meter) with small
inputs from the throttle stick. After accomplishing that, you can learn to take control with the direction
stick.
Problem: Blades can’t turn.
Cause: • ON/OFF switch is OFF.
• Weak battery.
Solution: • Set switch to ON.
• Recharge the battery.
Safety Tips
Trouble Shooting
Problem: Fire Strike Pro suddenly stops flying and drops.
Cause: Too little power.
Solution: Recharge the battery pack.
Problem: Loss of control.
Cause: • Another infrared control device is interfering.
• Strong lighting is interfering.
Solution: • Avoid other devices with infrared controls.
• Choose another flying location.
3. HOW TO LIFT-OFF (after Trimming):
• Place the FIRE STRIKE PRO on a smooth surface. An uneven floor surface will affect its take-off.
• Slowly increase the throttle.
• DO NOT look at the controller while flying. Focus on the FIRE STRIKE PRO.
• As soon as the FIRE STRIKE PRO leaves the ground, reduce the throttle slightly. Adjust the throttle as
necessary to maintain altitude.
• Gently add throttle if the FIRE STRIKE PRO descends.
• Gently reduce throttle if the FIRE STRIKE PRO climbs.
• For turning, give short and small inputs to the direction stick. (Most beginners will initially over-control the
FIRE STRIKE PRO.)
4. FLIGHT LOCATIONS:
Choose a location that meets the following criteria:
1. Indoors, with little air movement.Avoid circulating air from heating and air conditioning.
2. Room sizes should be at least 10 feet (3 m) wide x 10 feet (3 m) long x 8 feet (2.4 m) high.
3. Avoid flying in areas with electric fans, air conditioning, reading lamps or other objects that
could interfere.
2. HOW TO CONTROL FLIGHT:
Flying Your Fire Strike Pro (continued)
CAUTION: Changes or modifications to this product not
expressly approved by the party responsible for compliance
may void the user’s authority to operate the equipment.
© Copyright 2008 • 3008044
www.revell.com
Revell, Inc., a subsidiary of
Hobbico®, Inc., Champaign, IL 61826
Up and Down Hovering:
From steady flight, slowly pushing the throttle stick upward will make the
FIRE STRIKE PRO fly higher.To make it fly lower, simply lower the stick a
little. Smooth flying takes only small changes in the stick position.
Left and Right Turns:
Hold the FIRE STRIKE PRO steady in the air.
Push the direction stick left to turn left, and
push the direction stick right to turn right.
Moving Forward and Backward:
Hold the FIRE STRIKE PRO steady in the air. Push the
direction stick forward to move forward, and push the
direction backward right to move backward.
a
d. Adult supervision is r
equir
ed.
ControllerFire Strike Pro
C
ontents
C
™

Fire Strike Pro and Controller Parts
page 3page 2
Fire Strike Pro
Counter-rotating
rotor blades
Flybar
Flybar
Landing gear On/Off Power Switch
Charging jack
Controller
Infrared signal emitter
Power and charge
LED indicators
Throttle stick
Direction stick
Power/charge switch
Left and Right Trim
Dial
Forward and
Backward Trim Dial
Charge cord
Note: Before recharging the Fire Strike Pro’s LiPo battery after flying, always wait 10-15 minutes for it to cool down.
1. Turn off both the Fire Strike Pro and the controller.
2. Pull out the charge cord from the bottom of the controller.
(Pic 1).
3. Carefully plug the charging cord into Fire Strike Pro (Pic 2).
DO NOT FORCE. When inserted properly, the charging cord
should fit easily in the charging port. Incorrect insertion of
the charging cord will damage the Fire Strike Pro and may
create a hazard.
4. Turn the switch to the CHARGE position on the controller.
(Pic 3).
5. The controller’s Charge LED will start to flash. (Pic 4).
6. When the charge LED shines steadily without flashing,
charging is complete.
7. Turn controller switch to the ON position before flying the
Fire Strike Pro.
Remove the screw
to release the
battery cover for
battery installation
and removal.
Throttle Down Position
Note: Before turning
on the controller, the
throttle stick must be
in the down position.
Battery cover
1. Remove the screw
above the battery
cover by turning it
counter-clockwise
using a Phillips-head
screwdriver.
2. Install 6 “AA” size
batteries in the battery
compartment following
the polarity shown
inside.
3. Replace and
tighten the screw
clockwise.
Pic 1 Pic 2
Controller Battery Installation
Fire Strike Pro Charging Procedure
Flying Your Fire Strike Pro
• Gently push the throttle up to raise your Fire Strike Pro about 1.5 feet (0.5 meter) to 3 feet (1 meter) high.
1. HOW TO TRIM:
- +
+ -
- +
+ -
- + - +
Pic 4
Pic 3
The Fire Strike Pro can fly for about 5-6 minutes after 25-30 minutes of charging.
Then, set the
ON/OFF switch of the
Fire Strike Pro to ON.
With the throttle (or left)
stick of controller in the
down position, move the
controller’s power/charge
switch to ON. Place the Fire Strike Pro
on the ground with its
tail pointing toward you.
If the FIRE STRIKE PRO spirals to the left or keeps turning left, turn the left and
right trim dial clockwise until the FIRE STRIKE PRO no longer spirals.
If the FIRE STRIKE PRO constantly moves forward, turn the forward and backward
trim dial clockwise until the FIRE STRIKE PRO no longer moves forward.
If the FIRE STRIKE PRO constantly moves backward, turn the forward and backward
trim dial counter-clockwise until the FIRE STRIKE PRO no longer moves backward.
If the FIRE STRIKE PRO spirals to the right or keeps turning right, turn the left and
right trim dial counter-clockwise until the FIRE STRIKE PRO no longer spirals.
Spirals right or
Keeps turning right
Spirals left or
Keeps turning left
Constantly moves forward Constantly moves backward