RFI CC User manual

INS-41395-2
Please Ensure
SAFETY AT ALL TIMES

INS-41395-2 www.rfiwireless.com.au
Tools and equipment that may be required:
Sealing tape Electrical tape
Measuring tape
VSWR meter
Torque wrench
Spanner / Shifter
Any QUESTIONS contact your RFI representative.
1. Check Carton tube before taking out antenna to check for transport damage.

INS-41395-2
2. Check VSWR of antenna before installation
3. Install antenna upright (normal mounting) or upside down (inverted mounting)

INS-41395-2 www.rfiwireless.com.au
3.1 Install antenna upright (normal mounting) or upside down (inverted mounting)
Antenna Base Connector Block
Antenna Radome
Antenna
Mounting Tube
Converting drain hole to Inverted Mounting
Take out the
screw-Style drain
hole plug and refit
to the drain hole
at the connector
block
Drain hole
Antenna
Mounting Tube
Antenna Top Cap
SIDE MOUNTING TOP MOUNTING

INS-41395-2
4. SPACING, Antenna to STRUCTURE and CLAMPING dimensions
Band Frequency MHz Minimum Antennas to Structure spacing
(A)
Clamping dimensions
(B)
UHF
Inches mm Inches mm
380 31.1 790
19.7 500
400 30 762
415 28 712
430 27 686
445 27 686
460 26 660
475 25 635
490 24 609
505 23 584
520 23 584
800 MHz 746 - 870 16 400 19.7 500
Side Mounting Top Mounting
2”(50mm)
2”(50mm)
(B)
(A)
(B)
2”(50mm)
5. VSWR test the antenna after mounting.
VSWR <1.5:1
Full Band Coverage

INS-41395-2 www.rfiwireless.com.au
6. Torque connector (s) and weatherproof. Drain loop must be applied.
Connector Torque
Din = 18-22lbs/ft (25-30 Nm)
6.1 Screw together
and tighten based
on above specifications.
6.3 Drain loop applied.
6.1 Seal connectors
with suitable tape.
7. Take installation photos and store with VSWR results with site records.
VSWR test result
NOTE: DO NOT BLOCK
DRAIN HOLE