RFI FSA20-67-DIN User manual

ASSEMBLY INSTRUCTIONS
Before assembling your antenna please confirm all the components below are included in the kit.
406-512 MHz
FSA20-67-DIN
0A-20-67-DIN
DIPOLE ASSEMBLY
QTY: 1
LARGE CLAMP PLATE
QTY: 4
M-8562
SCREEN CENTRE
QTY: 1
M12 HEX NUT
M12 SPRING WASHER
M12 FLAT WASHER
M12x250 THREADED ROD
M12 STUD ASSEMBLY
QTY: 4
INS-40101-8 ©RF Industries Pty Ltd 2009
www.bird-technologies.com
PAGE 1 OF 4

406-512 MHz
SCREEN
$',1
',32/($66(0%/<
90°
2.5
M12 STUD
ASSEMBLY
190
145
2 MM (5.7")
TOP OF BOOM
TO TOP OF SCREEN
FSA20-67-DIN
ANTENNA ASSEMBLY
STEP 1:
ASSEMBLE THE DIPOLE TO THE SCREEN AS DEPICTED BELOW USING 2 OF THE 4 LARGE CLAMP PLATES
AND THE 4 M12 STUD ASSEMBLIES INCLUDED IN THE KIT.
TIGHTEN THE M12 NUTS TO 55Nm (40 lbf.ft). LEAVE APPROXIMATELY 190mm PROTRUDING OUT THE
BACK SIDE.
INS-40101-8 ©RF Industries Pty Ltd 2009
www.bird-technologies.com
PAGE 2 OF 4

406-512 MHz
FSA20-67-DIN
MOUNTING TUBE
(NOT INCLUDED)
LARGE CLAMP PLATE
ANTENNA MOUNTING
HARDWARE HAS
BEEN DESIGNED TO
ACCEPT MOUNTING
TUBE DIAMETERS IN
THE RANGE OF
50-75mm (2-3")
MOUNTING TUBE
LENGTH TO BE SIZED
BY INSTALLER TO
SUIT INSTALLATION
METHOD.
PLEASE NOTE
MOUNTING POLE
NOT SUPPLIED.
INS-40101-8 ©RF Industries Pty Ltd 2009
www.bird-technologies.com
PAGE 3 OF 4
ASSEMBLY INSTRUCTIONS continued
STEP 2:
WITH THE ANTENNA ASSEMBLY LOCATED ON THE MOUNTING TUBE ATTACH THE REMAINING 2 LARGE
CLAMP PLATES AND TIGHTEN THE M12 NUTS CLAMPING THE ANTENNA ASSEMBLY TO THE MOUNTING
TUBE. TIGHTEN TO 55Nm (40 lbf.ft)

406-512 MHz
FSA20-67-DIN
SCREENED ARRAY
ASSEMBLY
FSA-20-41-DIN
SCREENED ARRAY IS DESIGNED TO BE
FIXED TO A TOWER MOUNTED POLE OR
TOWER LEG.
ENSURE THAT MOUNTING POLE,
CLAMPS AND MOUNTING STRUCTURE IS
APPROPRIATELY SIZED TO SUIT LOCAL
WIND AND ICE INSTALLATION
CONDITIONS.
STRAIN RELIEVE FEED CABLE BACK
TO SUPPORT STRUCTURE. SEAL
CONNECTOR WITH A SUITABLE SELF
AMALGAMATING TAPE.
TYPICAL
INSTALLATION
SIDE VIEW
TOWER
MOUNT POLE
TOWER CLAMPS
OUTRIGGER
THESE ITEMS
NOT INCLUDED
IN ANTENNA KIT:
ASSEMBLY INSTRUCTIONS continued
TYPICAL INSTALLATION
INS-40101-8 ©RF Industries Pty Ltd 2009
www.bird-technologies.com
PAGE 4 OF 4