RFI FSA10-41-DIN Assembly instructions

Installation Sheet
FSA10-41-DIN
148-174 MHz
Copyright RF Industries Pty Ltd 2018. Subject to change without notice.
INS 41079-3rfiwireless.com.au
1
COMPONENTS
Assembly Instructions
Before assembling your antenna please ensure that all the components below are included in the kit.

Installation Sheet
FSA10-41-DIN
148-174 MHz
Copyright RF Industries Pty Ltd 201 . Subject to change without notice.
rfiwireless.com.au2
STEP 1
ASSEMBLE THE DIPOLE TO THE SCREEN AS DEPICTED BELOW ENSURING THE DIPLOLE TO SCREEN
SPACING IS SET CORRECTLY AND THE DRAIN HOLE IS FACING DOWNWARDS.
NOTE: VSWR TESTS SHOULD ONLY BE PERFORMED ONCE DIPOLE AND SCREEN ARE FULLY ASSEMBLED.
USING 2 OF THE 4 LARGE CLAMP PLATES AND THE 4 M16 STUD ASSEMBLIES INCLUDED IN THE KIT. TIGHTEN THE
M16 NUTS TO 70Nm (50 lbf.ft). LEAVE APPROXIMATELY 130mm OF THREAD PROTRUDING OUT THE BACK SIDE.

Installation Sheet
FSA10-41-DIN
148-174 MHz
Copyright RF Industries Pty Ltd 2018. Subject to change without notice.
INS 41079-3 rfiwireless.com.au
3
STEP 2
WITH THE ANTENNA ASSEMBLY LOCATED ON THE MOUNTING TUBE ATTACH THE 2 LARGE CLAMP PLATES
AND TIGHTEN THE M16 NUTS CLAMPING THE ANTENNA ASSEMBLY TO THE MOUNTING TUBE. TIGHTEN TO
70Nm (50 lbf.ft)

Installation Sheet
FSA10-41-DIN
148-174 MHz
Copyright RF Industries Pty Ltd 2018. Subject to change without notice.
INS 41079-3 rfiwireless.com.au
4