RH HUSTON User manual

HUSTON TASK TABLE LAMP
PARTS ENCLOSED
(A) Lamp Pole (1)
(B) Collar (1)

HUSTON TASK TABLE LAMP
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION BY A LICENSED ELECTRICIAN IS STRONGLY
RECOMMENDED.
1. Do not break or pull out LED bulbs.
2. Indoor use only.
3. Do not look directly at the light.
4. Keep lamp away from materials that may burn.
5. If the supply cord or adaptor is damaged, it must be replaced
only by service agent or a qualied technician.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the lightbulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
WARNING: This product can expose you to lead, which is
known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
THIS PRODUCT IS NOT A TOY AND HAS NO
PLAY VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 feet away from cribs, bassinets, and toddler
beds. Keep out of reach of children under 3 years of age.
ASSEMBLY & INSTALLATION
SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE FUSE
BOX OR CIRCUIT BREAKER PANEL.
1. Carefully remove all parts from the box and remove all plastic
coverings.
2. Loosen Collar (B) to adjust Lamp Pole (A) to the desired height.
3. Remove the plastic cover from the electrical plug.
4. Plug into proper electrical outlet and test xture.
5. Assembly is complete.
CARE INSTRUCTIONS
Do not use polishes or cleaners on the fixture. Wipe clean with a
soft, dry cloth.