RH MARTEL User manual

MARTEL TABLE LAMP
PARTS ENCLOSED
(A) Bulb
(B) Tripod Holder
(C) Lamp Body

MARTEL TABLE LAMP
IMPORTANT SAFETY INSTRUCTIONS
This fixture has been rated for up to one (1) 100-Watt maximum Type
A standard incandescent light bulb (not included), one (1) 23- Watt
compact fluorescent light bulb (not included), or one (1) 12- Watt LED
light bulb (not included). One (1) 4.5-Watt LED light bulb is included.
To avoid the risk of fire, do not exceed the recommended wattage.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the light bulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
WARNING: This product can expose you to lead, which is
known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
THIS IS NOT A TOY AND THE PRODUCT HAS NO
PLAY VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 ft away from cribs, bassinets, and toddler beds.
Keep out of reach of children under 3.
ASSEMBLY & INSTALLATION
1. Carefully remove all parts from the box and remove all plastic
covering.
2. Place the Lamp Body (C) on the floor.
3. Insert the Bulb (A) into the socket.
4. Attach the shade (not included) to the top of the Tripod Holder
(B).
5. Remove red protective plug cover from cord with plug.
6. Plug into proper electrical outlet and test fixture.
7. Assembly is complete.
CARE INSTRUCTIONS
Do not use polishes or cleaners on your lamp. Just wipe clean with
a soft cloth.