RIDGID NaviTrack FloatSonde User manual

NaviTrack FloatSonde User Manual
Using the NaviTrack
FloatSonde
The NaviTrack FloatSonde is a small, powerful,
battery powered device that transmits a 512Hz signal
to be picked up by the NaviTrack Sonde and Line
Locator. When introduced to a drain or sewer line
from a suitable access point, the unit floats and/or
rolls freely down the line.
Figure 1 – to turn the transmitter ON, press down firmly on
the top of the transmitter’s housing. The LED will illuminate.
Keep pressing until the LED begins flashing. To turn the
transmitter OFF, press and hold until the LED stops flashing.
During operation of the sonde, the LED will continue
to flash.
Figure 2 – a string may be attached to the ring on the bottom
of the transmitter for retrieval.
Features
Flushable
Simple, one-button operation
LED operation indicator
Integrated retrieval hook
Operates up to 10 hours on two user-replaceable
CR2032 batteries
Specifications
Size: 40mm (1.57”)
Weight: 27g
Operating Frequency: 512Hz
Frequency Tolerance: +/- 0.00005Hz
Typical maximum detection range in air with
NaviTrack receiver (varies with ambient noise and
interference): 10 ft
Red status LED
99 Washington Street
Melrose, MA 02176
Phone [phone]
Toll Free 1-800-517-8431
Visit us at www.TestEquipmentDepot.com

NaviTrack FloatSonde User Manual
Locating the NaviTrack
FloatSonde
The FloatSonde is weighted to position its core
vertically in order to produce a stronger signal for
locating. Because of the altered orientation, the
procedure for locating the FloatSonde differs from
that of a conventional sonde, which has a horizontal
core.
When locating with a horizontal sonde, a NaviTrack
receiver sees two poles and an equator. (Fig. 1)
When locating the FloatSonde, only one pole is
‘visible’. The equator and second pole cannot be
seen above ground. (Fig. 2)
Fig. 1 Fig. 2
Under normal conditions, the sonde will be located
directly below the pole, and the pole will be located at
the point of highest signal strength. If the pole and
highest signal strength are not located at the same
point, the sonde is tilted. (Fig. 3)
Fig. 3
Locating a tilted FloatSonde is similar to locating a
horizontal sonde. The equator and possibly the
second pole will be visible, depending on the angle of
tilt. A tilted sonde, however, will not be located
directly below the pole, or the equator. The
FloatSonde can still be located by finding the point of
maximum signal strength.
pole
pole pole
equator
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com

NaviTrack FloatSonde User Manual
Changing FloatSonde Battery Cells
1. Remove tape
2. Apply light pressure at equator of sonde with pliers
to disengage snap.
3. Replace both CR2032 battery cells
4. Return o-ring to its proper place in top shell.
(Properly engaged o-ring)
5. Fit internal assembly to supports on top shell.
6. Snap shells together and apply new tape around
equator.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com