Right Weigh 201 Series User manual

201-BR
Right Weigh Interior Bracket for 201 Series
Assembly Instructions
PP-003-0033 Rev A
December 2018
Right Weigh, Inc.
Hillsboro, Oregon, USA
www.rwls.com
©2018 Right Weigh, Inc. All rights reserved.

1. Choose a mounting
location in your
vehicle that permits
routing of air lines
and electrical
connections to the
gauge
2. Mount the base to
the vehicle using
any combination of
the supplied
hardware
5. Install the gauge adapter into the ring and hold
down using the 2 small screws on the side. Make
sure that the up arrow on the back of the bracket,
corresponds with the top of the gauge.
6. Following the instructions that came with your
gauge, connect any electrical and/or air lines and
attach the gauge to the bracket.
3. Assemble the slide into
the bottom of the ring.
Put the hose clamp
and rubber boot over
the assembly but do
not tighten the hose
clamp yet
4. The ring assembly
should now snap over
the ball. You may have
to loosen the hose
clamp slightly to allow
it to snap over the ball.
RING
BOOT
SLIDE