Rinnai RPC26WA User manual

HIGH
MID
LOW
HEAT
DRY
FAN
COLL
TIMER
SLEEP
SWING
F
C
Operation Manual
Portable Air Conditioner
Remote Controller

Rinnai 2 Portable AC Remote Controller OIM
NOTE
Before proceeding with the operation of your new Rinnai Portable Room Air Conditioner Remote
Controller, please read these instructions thoroughly and gain a full understanding of the
requirements features and operation of your new Remote Controller.
Please keep the Operation and Installation Manual for your new Portable Room Air Conditioner
handy so it can be referred to at any time in conjunction with these instructions.
REMOTE CONTROL OVERVIEW
1. ON/OFF Button
2. Fan Speed Button
3. Swing Button
4. Timer Button
5. Sleep Button
6. Temperature UP/DOWN Buttons
7. Fan Only Button
8. Cool Button
9. Dry (Dehumidifying) Button
BASIC OPERATION REMOTE CONTROLLER
The Rinnai Remote Controller allows for convenient operation of the appliance within a 8 metre range.
NOTE
A conrmation beep sounds to conrm that a successful controller input has been received by
the appliance.
BUTTON DESCRIPTIONS & OPERATION
1. "ON/OFF" Button
Press "ON/OFF" button to turn "ON" or "OFF" the Air Conditioner.
2. "SPEED" Button
Press "SPEED" to set the fan speed (LOW, MEDIUM or HIGH).
3. "+" and "-" Button to adjust temperature or time
(a) Press “+”and “-” to regulate the temperature (the unit is 1°C) and set the time (the unit is 1h).
The temperature ranges from 16° to 32°, and the time ranges from 1h to 24h.
4. "SWING" Button
Press "SWING" to turn "ON" or "OFF" the swing function.
5. "TIMER" Button
(a) When the air conditioner is turned "OFF", press "TIMER" to set a time to turn "ON" the Air Conditioner.
 Press"+"or"-"tosetthetime,andpress"TIMER"againtoconrmit.
(b) When the air conditioner is turned "ON", press "TIMER" to set a time to turn "OFF" the Air Conditioner.
 Press"+"or"-"tosetthetime,andpress"TIMER"againtoconrmit.
(c) After setting the time, press "TIMER" again to cancel the set time.
NOTE
After setting the time, press “TIMER” again to conrm it in 5 seconds. Without any operation
in 5 seconds, the air conditioner will conrm the time automatically. Pressing “TIMER” after
conrming the time this will cancel the set time.
2 3
1
9
6
4
5
7
8
GENERAL OPERATION

Rinnai 3 Portable AC Remote Controller OIM
6. “SLEEP” Button
(a) In operating mode, press “SLEEP” to enter the 10-hour intelligent sleep mode. After 10 hours, the air
conditioner will exit the sleep mode and restore its previous mode.
(b) In sleep mode, press “SLEEP” again, or press “MODE” or “ON/OFF” to exit the sleep mode.
NOTE
The sleep mode cannot be started in fan only mode.
7. “FAN” button - Press “FAN” to start the Ventilation mode.
8. “COOL” button - Press “COOL” to start the Refrigeration mode.
9. “DRY”button-Press“DRY”tostarttheDehumidicationmode.
NOTE
Only when temperature reaches 16° can you turn on the dehumidication mode.
FIT BATTERIES
1. Remove retaining screw of the cover. Slide down to open the cover according
to the direction indicated by the arrow head.
2. Install the button battery (CR2032/3V). Make sure the positive pole faces up.
3. Put back the cover and replace the retaining screw.
WARNING
KEEP BATTERIES OUT OF REACH OF CHILDREN
Swallowing button batteries may lead to serious injury in as little as 2 hours or death, due to
chemical burns and potential perforation of the oesophagus.
If you suspect your child has swallowed or inserted a button battery immediately call the 24hr
Poisons Information Centre on 13 11 26 for fast, expert advice.
Regularly examine the remote controller and make sure the battery compartment is completely
secured.
Dispose of used button batteries immediately and safely.
IMPORTANT
1. Aim the remote control towards the receiver on the front of Air Conditioner.
2. The remote control should be within 8 meters away from the receiver.
3. Ensure there are no obstacles between the remote control and the receiver.
4. Do not drop or throw the remote control.
5. Do not leave the remote control in the sun or near heating devices.
6. Only use the button battery (CR2032/3V). Ensure the battery cover is securely in place.
NOTE
The diagram shown on page 2 is an example only. The image contains almost all of the function
buttons.
Remote Controllers may be slightly di󰀨erent from illustrated diagram depending on which model
purchased.
2
0
3
R
2
C
2
0
3
R
2
C
12
3
GENERAL OPERATION

Rinnai 4 Portable AC Remote Controller OIM Issue 3 - January 2019
CONTACTS
Rinnai has a Service and Spare Parts network with personnel
who are fully trained and equipped to give the best service on
your Rinnai appliance. If your appliance requires service,
please call our National Help Line. Rinnai recommends that this
appliance be serviced at least every 2 years.
With our policy of continuous improvement, we reserve the
right to change, or discontinue at any time, specifications or
designs without notice.
Australia Pty. Ltd.
ABN 74 005 138 769
100 Atlantic Drive
Keysborough, Victoria 3173
P.O. Box 460
Braeside, Victoria 3195
AU45204
Product Sales & Service National Help Line
Tel: [phone]* Fax: [phone]
*Monday to Friday, 8.00am to 5.30pm EST
For further information visit www.rinnai.com.au
or email enquir[email protected]