RIOTEC OM7520M User manual

1
Programming Quick Guide
- OM7520M
Installation
Make sure that the scanner has the correct cable to plug in the PC as
below described:
Reset Configuration to Default :
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan USB HID. This will reset the scanner to its
factory defaults.
USB HID
Technologic Data:
lMotional Tolerance: 3.0 m/sec
lScan Speed: 60 frame/sec
lLight source: 620nm Red LED
lDepth of field: 13 mil EAN13: 260mm
20 mil QR code: 230mm
lSensor: CMOS (1280 x 1024 pixels)
lBest resolution: 1D (3mil): code 39
lPrint contrast: ≥20%
lInterface: USB HID
lInput voltage: 5 V/DC ±5%
lCurrent- operation: 300 mA
Max. current consumption: ≦500mA
lDimension: 82 x 88 x 156mm (W x D x H)
lWeight: 246g ±5g
Keyboard Country (FOR USB HID Only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ‘\ < > ~
USA
(Original setting)
France
Italy Spanish
Portuguese (Brazil) Portuguese (Portugal)
German
1D Symbologies –1
ENABLE CODABAR DISABLE
ENABLE CODE 39 DISABLE
ENABLE
Interleaved
25 DISABLE
ENABLE
Industrial
25 DISABLE
1D Symbologies –2
ENABLE Matrix 25 DISABLE
ENABLE CODE 128 DISABLE
ENABLE GS1-128 DISABLE
ENABLE UPC-A DISABLE
ENABLE
UPC-E DISABLE
ENABLE
EAN 8 DISABLE
ENABLE
EAN 13
DISABLE
ENABLE
CODE32
DISABLE
KBDCTY4

2
1D Symbologies –3
ENABLE
ISSN DISABLE
ENABLE
GS1DataBar
DISABLE
ENABLE
GS1 Databar
Limited DISABLE
ENABLE
GS1 Databar
Expanded DISABLE
ENABLE
ISBN DISABLE
ENABLE
CODE 93
DISABLE
ENABLE
CODE 11
DISABLE
2D Symbologies
ENABLE PDF 417 DISABLE
ENABLE
QR Code DISABLE
ENABLE
Micro QR
Code DISABLE
ENABLE
Data
Matrix
DISABLE
ENABLE
Aztec
Code
DISABLE
ENABLE
Micro
PDF417
DISABLE
Beeper setting
Beep on (default) Beep off
Volume low Volume high (default)
Low pitch Middle pitch (default)
High pitch Tone long (default)
Tone pip

3
USB keyboard update speed setting
Slow speed (default) Middle speed
Fast speed
lThe barcode is used to set the update speed when scanner is in
USB keyboard pattern. If the PC performance is lower, we
suggest you choose slow update speed to make sure the scanner
updates the right data.
USB keyboard Convert Case
Normal output (default) Case reversal
All Caps All Lower case
lScan the appropriate setting code (as above) to convert barcode
data to your desired case.
Example: When the convert All Lower case function is enabled,
the barcode data “AbC is transmitted as “abc”.
lInformation in this document is subject to change without notice.
Q_190911_01