Roadmaster 88336 User manual

ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
5805-01
1-800-669-9690
SEAT ADAPTER KIT #88336
INSTALLATION INSTRUCTIONS
Failure to follow these instructions can result in
property damage, personal injury or even death.
WARNING
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 360-896-0407 fax [phone] www.roadmasterinc.com
Parts List
(1) 3/8" lock washer (1) 1-1/8" pipe spacer
(1) 3/8" x ¾" bolt (1) 1-5/8" pipe spacer
(1) 10mm x 1.5 x 60mm bolt (2) 10mm lock washers
(1) 10mm x 1.5 x 75mm bolt (2) 3/8" flat washers
3
Instructions
1. Locate the mounting post (Fig.1) that came with your
BrakeMaster. If needed, order part number 450596. Now,
secure the post to the center of the seat adapter using the
included 3/8" x ¾" bolt and 3/8" lock washer. If the hole is
countersunk, use the Allen head bolt and lock washer includ-
ed with this kit.
2. Push the driver's seat back as far as it will go, and re-
move the two front seat track covers (Fig.2). They will not be
replaced.
3. Remove the two 13mm (head) seat track bolts attaching
the front seat track to the floor pan. Place the shorter pipe
spacer over the inside mount, and the longer one over the
outside mount (Fig.3).
4. Place the seat adapter over the pipe spacers you in-
stalled in the previous step. Note: make certain to position
the adapter so that the mounting post is directly in line to the
brake pedal. The BrakeMaster air cylinder may jam or func-
tion incorrectly if the mounting post is not directly in line with
the brake pedal.
continued on next page
2
Before Installation Installation Complete
Mounting
Post

1
1-1/8"
pipe spacer
1-5/8"
pipe spacer

ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
5805-01
1-800-669-9690
SEAT ADAPTER KIT #88336
INSTALLATION INSTRUCTIONS
Failure to follow these instructions can result in
property damage, personal injury or even death.
WARNING
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 360-896-0407 fax [phone] www.roadmasterinc.com
4. Bolt into the floor pan using the supplied hardware. Use
the 10mm x 1.5 x 60mm bolt, 10mm lock washer and 3/8"
flat washer over the mount with the shorter pipe spacer, and
the 10mm x 1.5 x 75mm bolt, 10mm lock washer and 3/8"
flat washer over the longer pipe spacer (Fig.4).
5. Attach the BrakeMaster to the brake pedal and to the
seat adapter. Adjust the length of the air cylinder assembly,
per the BrakeMaster installation instructions, ensuring that
the BrakeMaster is pulling back on the brake pedal so the
pedal is only depressed when the brakes are engaged at
the motorhome. Failure to adjust the assembled length of
the BrakeMaster may result in severe brake system damage
and/or complete failure of the brakes.
4
continued from previous page