Rockler HPL Installation guide

1
HPL Router Tabletop
Assembly Instructions
1HPL Tabletop 1
2 #6 x 3/4" Wood Screw 12
3 7 x 40mm Plate Leveling Screw 8
PARTS list - HPL Router Tabletop Quantity
Thank you for purchasing Rockler's HPL Router Tabletop. It combines a bright, durable surface with plate-leveling
features and a dual-track miter slot to provide great visibility and years of precise, low-friction routing. Please
read these instructions thoroughly before assembly.
2
3
1

2
46924
Rev 09/14
Distributed by Rockler Companies, Inc.
©2014 Rockler Woodworking and Hardware
Install the Leveling Screws
1. Install the 7 x 40mm Plate Leveling Screws (3) up
through the predrilled holes in the lip of the opening
for the router plate. Fig. 1.
2. Install the router plate and adjust the screws' height
 untiltherouterplateisushwiththeHPLTabletop(1).
Attaching to Steel Router Table Legs
1. Set the HPL Tabletop (1) on the assembled Steel
Router Table Leg Set (48426, sold separately),
aligning the predrilled holes in the underside of the
top with the mounting holes in the steel stretchers.
2. Use #6 x 3/4" Wood Screws (2) in all 12 holes to
attach top and stand. Fig. 2.
Fine-Tuning for Flatness
As with other tool tables, you might need to shim your
routertabletoachieveormaintainaperfectlyatsurface.
If it's on a Rockler Steel Router Table Stand, simply follow
these steps:
1. Remove the middle mounting screws on the front
and rear stretchers.
2. Insert a small metal washer between each stretcher
and the tabletop. Fig. 3.
3. Reinstall the mounting screws through the washer
and into the top.
Steel Stand Sides
2
1
Fig. 1
Fig. 2
Fig. 3
1
2
Steel Stand
Stretcher
Washer
3
1