ROSE DISPLAYS GOTCHA WITH V CLIP User manual

21 Lime Street, Marblehead, MA 01945
Tel# [phone] Fax# [phone]
e-mail:[e-mail]
The Gotcha® is a registered trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #99INSGOVCLP
Parts
Instructions for Hanging
Instruction Sheet
Step 1
Place poster on a flat surface. Snap the
Gotcha open and insert poster (top and bottom).
To close, snap the Gotcha shut. Fig. 1
Note: It is easier to open and close the Gotcha by
starting at one end, and working your way down
the holder.
Step 2
Insert Gotcha Clips into slot on backside of the
top Gotcha only. (You should hear a "SNAP"
when the clips are inserted properly). Fig. 2
Note: For best results, place the clips 1/3 of the
way in from each end on the top Gotcha holder.
Step 3
Attach V Clip to ceiling grid.
Step 4
Attach one end of Jet wire to V Clips and the
other into the Gotcha clips. Fig. 2 & 3
Slowly pull sign down to desired level. Jet Wire
stretches to 48”.
Important note:
Please save and reuse the Gotcha Holder, V Clips
and Gotcha clips for future projects.
V Clip
12G100
Gotcha Clip
12G100
Gotcha
12G100
Jet Wire
12G100
Gotcha
®
Instructions for Hanging
Incept-3.1.99
Figure 1
Figure 2
Figure 3

21 Lime Street, Marblehead, MA 01945
Tel# [phone] Fax# [phone]
e-mail:[e-mail]
The Gotcha® is a registered trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #99INSGOVCLP
Parts
Instructions for Hanging
Instruction Sheet
Step 1
Place poster on a flat surface. Snap the
Gotcha open and insert poster (top and bottom).
To close, snap the Gotcha shut. Fig. 1
Note: It is easier to open and close the Gotcha by
starting at one end, and working your way down
the holder.
Step 2
Insert Gotcha Clips into slot on backside of the
top Gotcha only. (You should hear a "SNAP"
when the clips are inserted properly). Fig. 2
Note: For best results, place the clips 1/3 of the
way in from each end on the top Gotcha holder.
Step 3
Attach V Clip to ceiling grid.
Step 4
Attach one end of Jet wire to V Clips and the
other into the Gotcha clips. Fig. 2 & 3
Slowly pull sign down to desired level. Jet Wire
stretches to 48”.
Important note:
Please save and reuse the Gotcha Holder, V Clips
and Gotcha clips for future projects.
V Clip
12G100
Gotcha Clip
12G100
Gotcha
12G100
Jet Wire
12G100
Gotcha
®
Instructions for Hanging
Incept-3.1.99
Figure 1
Figure 2
Figure 3