Rosen AV8900H User manual

Dual Multimedia
Headrest Replacement
Entertainment System
Quick Start Guide

About the Registered Marks
This item incorporates copy protection technology that is protected by U.S. patents
and other intellectual property rights of Rovi Corporation. Reverse engineering and
disassembly are prohibited.
NOTE: Features and specications listed in this manual are subject to change
without notice
Manufactured under license from Dolby Laboratories.“Dolby” and the double-D
symbol are trademarks of Dolby Laboratories.
iPod®and iPhone®are registered trademarks of Apple, Inc.
NOTICES
NOTICE OF INTENDED USE
Rosen Electronics products are designed to enable
viewing of video for rear-seat occupants ONLY, and are not
intended for viewing by the driver while the vehicle is in
motion. Such use might distract the driver or interfere with
the driver’s safe operation of the vehicle, and can result in
serious injury or death. Such use might also violate state
or local laws.
Rosen Electronics disclaims any liability for any
bodily injury or property damage that may result from
any improper or unintended use.

For complete Owner’s Manual, please visit
Rosen Electronics online at
www.rosenelectronics.com

1
Turning On the System
A) Turn vehicle ignition to ON or ACC position.
B) Press POWER on the front control panel on each monitor.
Front Panel Controls
HOME/BACK
SPEAKER
UP/FAST REWIND
LEFT/PREVIOUS
POWER/ENTER
RIGHT/NEXT
DOWN/FAST FORWARD
PLAY/PAUSE
EJECT

2
A) Turn on the headphones by pressing the OFF/ON button located on the right
ear piece. The power LED on the ear piece will illuminate yellow for Channel A
and green for Channel B. If not, check that the batteries are inserted properly
and has a charge.
B) Each headphone has a two-position slide switch labeled “Ch.A/Ch.B”.
For proper operation, headphones must have a clear line of sight to the
corresponding headrest monitor being used and must be switched to the
designated A/B Channel.
C) To adjust the volume level, use the knob on the ear piece.
Using the Headphones
Remote Control
Home
Eject
Enter
Return

3
Playing a Disc
A) On the HOME screen, use the LEFT or RIGHT button and navigate to DVD
mode.
B) Press the ENTER button to select DVD source.
C) The unit will resume play when a disc is present. Press EJECT to remove a
loaded disc.
D) Insert a disc into the slot above the monitor. Do not force any disc into the
slot. When the DVD menu appears on the screen, press PLAY or ENTER as
instructed on the screen. Most discs will load and play automatically.
Note: Not all discs are supported by this system. You may experience certain
discs to be incompatible and will not play on this system but will work on other
players. Various disc manufacturers change technologies from time to time which
may create compatibility issues. This is not a problem with the unit and is not
covered by the manufacturer warranty.
Please check with the Owner’s Manual for more detailed information.
To View the Same Image on Both Screens
A) Power on the second unit.
B) Select OTHER SCREEN on the HOME screen or press the SOURCE button
on the included remote control until OTHER appears on the screen. Your monitor
will now display the same image as the other/opposite unit.

4
External Sources
HDMI: The system supports audio video placyback from up to two (2)
external HDMI devices, such as smart phone, tablet, gaming console and
other devices with HDMI output. *Proper HDMI adapter must be used.
AUX: Standard composite video signal from a video device can be used with
the system by using the standard 3.5 inch adapter. The AUX input is located
on the media interface module
AV IN: Standard composite video signal from a portable device can be used
with the system by using the 3.5 inch adapter. The AV IN input is located at the
front, left bottom corner of the monitor.
A) Return to the HOME screen by pressing the HOME button on the front control
panel or the remote control.
B) Use the LEFT or RIGHT button to navigate to the desired source.
C) Press ENTER to select the source.
Changing the Video Source
The USB/MicroSD sources can be used for media playback, such as video,
audio and photos.
Use the LEFT or RIGHT arrows to move to the next page.
Use the UP or DOWN arrows to navigate through the folder.
PLAY/PAUSE or ENTER to start playing le.
Use the HOME button to return to the main menu.
Digital Media Player
RETURN to go back to a previous screen.
Note: While the video is playing, the arrows on the remote control can
be used to change the subtitle and audio track if present.
Use the LEFT key for subtitle.
Use the RIGHT key for audio track.

5
A) Press the SPEAKER button on the front control panel.
“PRESS OR TO ADJUST xxx.x mhz” will appear on the screen.
B) Turn the vehicle’s radio on and tune to the same FM frequency displayed
on the screen.
C) If radio interference is heard, try another frequency.
Listening Over the Vehicle Speakers
Adjusting the Display
From the Home page, navigate to Settings and press Enter.
Press the UP arrow button to brighten the screen or press the DOWN arrow
button to dim the screen. Once you are done, press the BACK or HOME
button to exit the SETTINGS.
The system can be set to turn on automatically whenever the ACC is on. To set
the system to turn on automatically, within the SETTINGS menu press the LEFT
arrow button to select Auto On Display. Press either the UP or DOWN arrow
button to change settings.
Auto On Displays

Copyright © 2015 Rosen Electronics, All rights reserved.
PN: QSG1002 Rev A