Rosen GM1CAMHD User manual

Multimedia
System
Quick Start Guide
GM1CAMHD
Application: For models equipped with MyLink
and IntelliLink color displays.

NOTICE OF INTENDED USE
Some features of Rosen Electronics are not intended for viewing by the driver when the vehicle is in motion, such as movie
playback. When using navigation, minimize the amount of time spent viewing the screen and use voice prompts as much
as possible. Avoid prolonged use of the touch screen controls. Such use might distract the driver or interfere with the
driver’s safe operation of the vehicle, and thus result in serious injury or death. Such use might also violate state or local
laws.
Rosen Electronics disclaims any liability for
any bodily injury or property damage that might result
from any improper or unintended use.
ABOUT THE REGISTERED TRADEMARKS
This item incorporates copy protection technology that is protected by U.S. patents and other
intellectual property rights of Rovi Corporation. Reverse engineering and disassembly are
prohibited.
NOTE: Features listed in this manual are subject to change without notice.
Copyright © 2015 by Rosen Electronics, All rights reserved. Except as permitted under the
Copyright Act of 1976, no part of this publication may be reproduced or distributed in any
form or by any means, or stored in a database or retrieval system, without the prior written
permission of Rosen Electronics.
3

4 5
Entering Media Mode
The Basics
To Enter/Exit Media Mode, press and hold Media
button located on steering wheel for two seconds.
Main Menu
Movies: Lists movies from USB only.
(Dolby Digital not supported)
Music: Lists music from USB only.
Photo: Lists photos from USB only.
Settings: Enter settings menu.
HDMI: Enter HDMI mode.
AUX: Enter AUX mode.
Camera: Enter camera mode.
Using Rosen CAMHD
To listen to audio from USB/AUX/HDMI, place
OEM Radio in “AUX” source. Enter Rosen
Media and select desired source.
When listening to audio from OEM radio and
Smart-based Navigation app is desired, enter
Rosen Media and select HDMI. Touch the
screen to show top bar then press the speaker
icon, so it now displays a line through it.
This will allow Navigation prompts to be heard
(when applicable).

4 5
Beep: Touch screen beep On/Off
Unit: Select between Feet or Meters.
Reverse: Camera On/Off setting.
If no camera is equipped, set to Off.
Sensor: If EchoMaster ParkAlert sensors and
Rosen camera are installed, select On.
Main Settings
To enter Installer settings, select “Settings”
from the Main Menu.
Advanced Settings
From the Main Settings page, press button at
top right of screen and enter “1120” Ok.
Camera: Switch between “Factory” or “Rosen”.
Radio Type: Select number of shortcut buttons
shown at the upper part of OEM radio screen
(3 or 4). The conguration ensures proper
functionality. (Only applicable to GM3CAMHD)
AP Update: Use for updating FW for Rosen
system.

Copyright © 2015 Rosen Electronics, All rights reserved.
DBP-1054 Rev A