CONTENT:
1. Exploded Drawing..........................................................2 2. Part List.................................................................................2-3
3. Cautionary Notes ............................................................3 4. Assembly Method.................................................................4
5. Trouble Shooting ........................................................5-6 6. Recommended Parts List ...................................................6
1. Exploded Drawing:
2. Part List:
(No.) (Q’ty) Description Material (No.) (Q’ty) Description Material
11 Cover Plastic 81 Motor Plastic
21 Switch Plastic 91 Bottom ABS
31 Filter Cover ABS 10 6 Screw Metal
41 Filter Plastic 11 4 Rubber Pad NBR(65°C)
51 Upper Case ABS 12 1 out tube NBR(65°C)
61 Wire Plastic/Metal 13 1 In tube NBR(65°C)
74 Motor Sponge NBR (65°C)
3. Cautionary Notes:
• This machine is not advised to be used in an environment with ammable and explosive materials.
• Please read the instruction manual carefully before using the machine.
• Please clean the medication cup, mouthpiece and masks before using the product for the rst time.
• The product is designed for single patient’s use. Please do not use the machine for more than one patient to avoid
cross transmission.
• Do not use the machine if runs out of the lter.
• Please unplug the machine after use.
• Please clean then air-dry the nebulizer kit after every use to avoid clogging.
• Please do not use the machine in an environment with possible exposure to water such a bathroom, kitchen and
etcetera to avoid electric shock.
• Do not place the machine near a sink or bathtub. Please unplug the unit immediately if the above circumstances
occur.
• Please do not use the machine during sleep. Children should not use the machine without the supervision and
instruction of adult.
• Please make sure the machine remains o, unplugged and well-stored while not in use.
• Please use the machine in an environment with good ventilation
• Please stay from the machine plugged while lling the liquid medication to avoid electric shock.
• The motor in the machine, equipped with a temperature control switch, will stop operating when it is overheated
and will be able to operate again after its temperature drops back to normal (approximately 20 minutes).
• Do not attempt to disassemble the machine, which invalidate the warranty as well as might cause malfunction.
• Please follow the physician’s instruction before using the machine. Also, please contact the local distributor if there
is any questions.
4. Assembly Method:
1. Place the nozzle
into the Cover and
diverter
2. Screw the cover
tight to the
medication cup
3. Slide the
mouthpiece onto
cover
4. Connect the
air tube and
the opening at
the bottom of
medication cup
5. Connect the other
end of the air tube
and the vent hole
of the nebulizer
6. Take o the
mouthpiece if you
would like to use a
mask
7. Replace the
mouthpiece with a
mask
