Rossmax NB500 User manual

For a�er sales service, pleasecontact Cypress Medic Sdn Bhd (www.cypressmedic.com.my)
Rossmax Nebulizer NB500
Quick Guide
How to use nebulizer NB500
1. Assembling your nebulizer kit
Follow the cleaning instrucons in this guidebook under “Cleaning technique” prior to using your
nebulizer for the rst me or aer it has been stored for an extended period of me.
REMEMBER: Always unplug the compressor and make sure the power-switch is turned to the “OFF”
posion before cleaning, assembling and before or aer each use.
1. Place the compressor on a t, stable surface within reach.
2. Gently twist and pull straight up on the lid of the nebulizer to separate into two parts (medicaon cup
and cover).
3. Make sure that the nozzle is properly installed inside the medicaon cup. The stem inside the
medicaon cup inserts into the tube of the nozzle.
4. Add the prescribed amount of medicaon to the medicaon cup.
5. Reassemble the nebulizer by carefully twisng the medicaon cup and cover together.
Make sure that the two parts t securely.
2. Operating your nebulizer
The nebulizer is operable at up to a 45° angle. If the angle is greater than 45°, no aerosol will be
generated.
1. Ach one end of the air tube connector to the air output.
2. Carefully aach the opposite end of the air tubing connector to the stem at the base of the nebulizer
kit.
3. Ach the angled mouthpiece or mask to the top of the nebulizer.
4. The capacity of the medicaon cup is 2~5 ml.
NOTE: A 30-minute interval is recommended aer each use.
3. Steps of keeping procedure
Aer every use:
1. Unplug the unit from the power source.
2. Allow the unit to completely cool.
3. Carefully detach the air tubing from the nebulizer and pour out any remaining medicaon.
4. Follow the cleaning procedures provided in this guidebook.


For a�er sales service, pleasecontact Cypress Medic Sdn Bhd (www.cypressmedic.com.my)
Cleaning Procedure
Rinsing technique (performed aer each treatment or before rst use).
1. Make sure that the power-switch has been turned to the “OFF” posion and the unit has been
disconnected from the power source.
2. Disconnect the air tube from the nebulizer device.
3. Gently twist and pull up the cover of the nebulizer kit to open and separate.
4. Rinse the nebulizer kit and components with hot tap water.
5. Dry with clean towels or completely air dry.
6. Reassemble the nebulizer kit.
NOTE: For the rst me cleaning or aer the unit has been stored for an extended period of me, thoroughly
clean all components, including the air tube. The nebulizer kit is dish-washer safe.
Cleaning the compressor
Wipe the compressor daily using a soloth.
NOTE: Any other form of cleaning or cleaning agents may damage the nish of the unit.
Changing the air filter
It is important to change the air ter approximately when the air ter turns gray. It is recommended to
change air ter every 2 months.
1. Remove the air ter cover by gently pulling forward.
2. Discard the gray ter.
3. Replace with a new, clean air ter.
4. Securely re-aach the air ter cover to the unit.
NOTE: Air ters cannot be cleaned or washed. Only NB80 air ters can be used. Do not substute alternate
material such as coon. Do not operate without an air ter.