Rowlinson Garden Products Willow Gazebo User manual

Before assembly
•We recommend that time is taken to read the
instructions before starting assembly,then
follow the easy step by step guide.The
instruction sheet is only a guide to the
assembly.Certain items may not be shown
to scale.
•Check all components prior to assembly
•This product should be assembled by no
less than 2 people.
•Never attempt to erect the assembly in high
winds.
Recommended tools for assembly
•Step Ladder
x 2
No. Components Qty.
1Door Panel 1
2Window Panel 4
3Back Panel 1
4Roof Panel 6
5 Finial 1
6Pegs 6
No. Fixing kit Qty.
7Zip ties 100 123
4
5
6
5. Securing to the ground
Ensure the gazebo is in the desired position. For each corner of the wall panels Loop a zip tie through the bottom
most zip tie and through the eye of a peg.Push the peg into the ground and tighten the zip tie.
Zip tie at the bottom of each corner of
the wall panels
Loop the zip tie through the wall panel
corner bottom zip tie the eye of the
peg.
Push the peg firmly into the ground
before tightening the zip ties
6.Tighten all zip ties
Finish by fully tightening all the zip ties and if needed trim of the excess tails of the ties.
7
Caution
The willow Gazebo is best positioned in a
sheltered area of the garden. We also
recommend that theWillow Gazebo be taken
down if high winds are forecast.
Willow Gazebo
Assembly Instructions English SS158A
2006 © Rowlinson Garden Products Ltd
If in doubt of any aspect regarding the assembly,use or safety of your gazebo please contact us :
Help Line (Normal Office Hours) 01829 261 121
ROWLINSON GARDEN PRODUCTS LIMITED
Unit 2 Green Lane
Wardle Nr.Nantwich
Cheshire
CW5 6BN
Tel :[phone]
Fax :[phone]
We constantly improve the quality of our products,occasionally the
components may differ from the components shown and are only
correct at time of printing. We reserve the right to change the
specification of our products without prior notice.

3. Finial
Position the finial Centrally onto the point of the roof panels and secure using 2 x zip ties.
1.Wall panels assembly
Open out the 6 wall panels and arrange into a hexagon shape. Secure the 2 open ends together using 4 x zip ties,
do not fully tighten the ties at this stage.
Join the 2 open ends together
Zip ties
Ensure the bottom zip tie is positioned about
150mm from the bottom of the 2 panels
Zip ties
Loop the zip ties through the roof
panels and around the top frame of the
wall panels.
Zip ties
Zip ties
Zip ties
Zip ties
Ensure the roof is positioned
centrally with equal overhang
all round.
Zip ties
Zip ties
2. Roof panels assembly
Open out the roof panels and arrange into a 6 sided cone shape. Secure the 2 open ends using 3 x zip ties,Do not
fully tighten the zip ties at this Stage.
4. Roof toWall panels
Lift the roof onto the wall panels,ensure that the corners of the roof line up with the corners of the walls.Adjust the
wall panels making sure they are standing straight with the roof sitting centrally with an equal overhang all round.Once
in position secure each roof panels to the wall it is sitting on using 2 x zip ties.