Royal Sovereign ARP-3012 User manual

Royal Centurian Inc.
PORTABLE AIR CONDITIONER
ACONDICIONADOR DE AIRE PORTÁTIL
Read and retain these instructions for future reference
ARP- 3012
OWNER’S MANUAL
For any Customer Support needs please
choose the Customer Support tab on
www.royalsovereign.com

PORTABLE AIR CONDITIONER
Model ARP-3012
INTRODUCTION
Thank you for choosing this air conditioner to provide you and your family with all of the "Home Comfort" requirements for your home,
apartment, or office. This appliance can be moved from room to room and set-up in just minutes.
It is a multi-functional room air conditioner that offers you Cool, Dehumidify, and Independent Fan modes.
This manual will provide you with valuable information necessary for the proper care and maintenance for you new appliance.
Please take a few moments and read the instructions thoroughly. If properly maintained, your appliance will give you many years of
trouble free operation.
Electrical Specifications
1. All wiring must comply with local and national electrical codes and be installed by a qualified electrician. If you have any questions
regarding the following instructions,contact a qualified electrician.
2. Check available power supply and resolve any wiring problems before installation and operation of this unit.
3. For your safety and protection, this unit is grounded through the power cord plug when plugged into a matching wall outlet. If you are
not sure whether the wall outlets in your home are properly grounded, please consult a electrician. Do not use plug adapters or
extension cords with this unit.

WARNING
Improper handling can cause serious damage to the appliance. Read this manual carefully before operating the unit.
3
Do not cover the
air outlet while in
use.
Do not wet the
housing or control
panel.
Do not allow
children to play
with the controls or
drop any objects
into the outlet.
Always turn the
unit off and remove
the power plug
from the socket
when cleaning.
Do not place
objects or let any
person sit on top of
the unit.
Do not attempt to
remove any part of
the casing unless
by an authorized
technician.
Use only the
correct power
supply AC
115V/60Hz.
Remove the plug
from the socket if
the unit is not
being used for long
period.
Do not operate the
unit with damaged
plug or loose
socket point.
Make sure that the back of the unit is at least 4" or more from a wall. Do not place the unit in front of curtains or drapes.
WARNING
-If the power cord on this unit is damaged, it must be replaced by the manufacturer service agent or qualified electrician.
-This appliance is not intended for use by children or other persons without assistance or supervision.
ARP-3012

4
DESCRIPTION OF COMPONENTS
1. Air Outlet(Up -Down)
2. Control Panel
3. Front panel
4. Handle
5. Casters
6. Screen filter
7. Air intake (Evaporator)
8. Air intake (Condenser)
9. Air outlet (Heat exchange)
10.Water drain with plug
1
9
10
4
5
2
7
6
8
3

5
1. Insert ends of exhaust hose into exhaust nozzle connector and exhaust hose connector by twisting clockwise
until it stops.
2. Attach the exhaust hose connector onto the rear outlet of the unit and turn to the right.
3. Attach the exhaust nozzle to the window spacer with the 4 screws provided.
4. Connect the exhaust nozzle connector to the exhaust nozzle.
5. Extend the exhaust hose and close the window as far as possible trapping the exhaust nozzle as shown below .
INSTALLATION INSTRUCTIONS
Connect exhaust hose assembly to the back of the unit. Extend hose to desired length and locate the exhaust nozzle through a window or
wall for ventilation.
EXHAUST ASSEMBLY AND INSTALLATION
Window spacer Exhaust nozzle connector Exhaust hose Exhaust hose connector
ARP-3012
INDOOR INDOOR
INDOOR

6
POWER CONTROL
The power control turns the unit on and off.
WARNING CONTROL
Condensed water may accumulate in the unit . If the internal tank becomes full, the Warning Light will shine and the unit will not operate until
the unit has been drained.
FAN MODE
When fan mode is selected the indicator light will shine green. Air is circulated throughout the room with no cooling.
NOTE: Unit does not need to be vented in fan mode.
MODE CONTROL
The Mode Control has three settings:
Cool Dehumidify Fan
The settings are adjusted with the Mode Control button. A light will indicate which setting is currently being used.
FAN SPEED CONTROL
The Fan Speed Control has 3 settings: High, Medium, and Low.
OPERATION
Control panel
Fan Speed Control
Mode Control
Timer / Temp Set Control
Power Control
Display
Warning Light

DEHUMIDIFY MODE
When dehumidify mode is selected, the indicator light will shine green. Air is dehumidified as it passes through the unit, without being in full
Cooling mode.The fan will operate in Medium speed. Fan speed is not adjustable in Dehumidify mode.
NOTE: The air exchange hoses must vent inside the room when using Dehumidify mode.
COOL MODE
When Cool mode is selected, the indicator light will shine green. During the Cool mode the air is cooled and hot air is exhausted to the
outside through the exhaust tube.
NOTE: The air exchange hoses must vent outside the room when using Cool mode.
TIMER / TEMP SET CONTROLS
Used for adjusting the timer and thermostat.
The default display is the room temperature.
In Cool mode, when "+" or "-"button is pressed, the set temperature is displayed and may be adjusted. After 5 seconds the display will
revert back to room temperature . Temperature is only adustable in Cool mode . The time is adjustable between 1~24 hours.
NOTE: By pressing both Timer /Temp set buttons at the same time, the display will toggle between Celsius and Fahrenheit.
TIMER
Auto turn off:
With machine in Fan mode, press timer button to select number of hours you would like the unit to run in Cool mode until it
automatically shuts off.
Auto turn on:
With machine powered off, press timer button to select number of hours until you would like the unit to automatically start running in Cool
mode.
AUTOMETIC RESTART
When the power return, automatically returning to the previously set operating mode and parameters.
7
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
ARP- 3012

8
A/C Fan Speed Button
(High,Medium or Low)
Mode Button
(Select Cool,Fan or Dehumidify)
Timer and thermostat
Setting Buttons
Fahrenheit / Celsius
Selector
Timer ON/OFF Button
LCD Screen
OPERATION
Power ON / OFF
Button
Auto Swing
Air Conditioner Remote Control
The functions work the same as your air conditioner's touch controls. TIMER PROGRAMMING
1. Press the button on the remote or the
"Timer Setting" button on the control panel to
turn on the Timer Function.
2. Press the or buttons on the remote or
the +or - buttons on the control panel to set
the desired shut-off period.
3. The unit will shut off when the set time
elapses.
OSCILATING MODE
Press (SWING) on the oscilate wind direction
left to right, right to left.
OPERATIONDEHUMIDIFICATION OPERATION
Press the button on the remote or the
"MODE" button on the control panel to select
the Dehumidify mode. When the Dehumidify
mode is on, the temperature buttons and the
fan speed buttons do not function and the fan
will operate on low speed. The Dehumidify
indicator light will illuminate and stay solid while
the unit is dehumidifying. When the humidity in
the room is 50% or lower, the compressor will
not run, the unit will not dehumidify, and the
Dehumidify light will blink. Remember, the
exhaust hose does not need to be used in
Dehumidify mode.

TROUBLESHOOTING
Does not run
Operates for short time only
Runs but not cooling
Does not run and water full indicator lights
If the protector strip or fuse is blown:
Please wait for 3 minutes and start again, protector device may be
preventing unit from working.
If batteries in the remote controller need replacement.
If the plug is not properly plugged in.
If the set temperature is close to room temperature, you should lower the set
temperature.
Air outlet may be blocked by obstacle. Take the obstacle away.
If the door or window is open.
If there is other appliance heating room, such as heater or lamp,etc...
Check air filter, clean if necessary.
If the air outlet or intake is blocked.
If the set temperature is too high.
Drain the water into a prepared container by the drainage pipe on the rear
panel of the unit.
If still doesn't work, please consult a qualified technician.
Trouble Analysis
The following cases may not always be a malfunction. Please check it before asking for srvice.
9
ARP-3012

10
TROUBLESHOOTING
Appliance maintenance
Air filter maintenance
It is necessary to clean the air filter after using it for about 100 hours. Clean it as follows:
1. Cut off the power supply
Turn off the appliance first
before disconnecting from
power supply
1. Stop the appliance and
remove the air filter
2. Clean and reinstall the air filter
Wash it with a solution of
detergent in lukewarm water.
After cleaning, dry it,
then reinstall it...
3. Clean the air filter every two
weeks if the air conditioner
operates in an extremely dusty
environment.
2.
Wipe with a soft and dry cloth
Use lukewarm water to clean
the appliance.
3. Never use volatile substance
such as gasoline or polishing
powder to clean the
appliance.
4. Never sprinkle water onto
the main unit.
Dangerous!
Electric shock!
Stop the appliance
first, then pull back
the air filter.
Maintenance after using
1. If the appliance will not be used for a long time, be sure to pull out the rubber plug of the drain port in order to drain the water.
2. Keep the appliance running with fan only for a half day to dry the appliance inside and prevent mold.
3. Stop the appliance and pull out the power supply plug, then take out the batteries of remote controller.
4. Clean the air filter and reinstall it.
5. Remove the air hoses.