RRS LCF-10P User manual

LCF-10P FOR AF-S NIKKOR
70-200mm f/2.8G ED VR-I/II
SPECIFICATIONS:
Weight .............................................0.35 ounces / 10g
Material .......................6061-T6 anodized aluminum
Dimensions.................1.0” x 1.275” / 26mm x 32mm
Height of Mounting Plate section ..0.145" / 3.68mm
Total Height ......................................0.300" / 7.62mm
Comes with four flat head M2-0.4 x 8 and two flat head
M2-0.4 x 6 and black oxide steel screws, one 0.05” hex key.
Not compatible with the newer 2016 Nikon
70-200mm f/2.8E FL ED VR
MAINTENANCE
General Care
Prevent grit from fouling the surface of the LCF-10P.
Periodically use included hex key to check security
of mounting screws. Seat hex key firmly and use
care to prevent stripping hex socket head.
Cleaning
Wipe LCF-10P clean with a dry cloth to remove any
contamination prior to installing lens collar foot.
GUARANTEE
ALL REALLY RIGHT STUFF BRAND PRODUCTS
ARE GUARANTEED TO THE ORIGINAL
PURCHASER TO BE FREE OF DEFECTS IN
MATERIALS OR WORKMANSHIP FOR FIVE
(5) YEARS FROM THE DATE OF PURCHASE.
PRODUCTS WILL BE REPAIRED OR REPLACED
AT OUR OPTION.
® ,™,© 2017 Really Right Stu, LLC. All rights reserved.
TOP VIEW
Replaces thin aluminum
plate mount on the lens
collar. This is where the
removable lens collar foot
slides onto the collar.
LCF-10P is 2½ times thicker
than original Nikon plate
mount.
1146 Farmhouse Lane,
San Luis Obispo, CA 93401 USA
1-805-528-6321 | 1-888-777-5557
www.ReallyRightStu.com

INSTALLATION
1. Remove lens collar foot.
2. Use JIS or "00" Phillips screwdriver (not included) to
remove the four mounting screws on the Nikon lens
collar mount plate. Seat tool firmly and use care to
prevent stripping head.
3. Lift off Nikon lens collar mount plate and put LCF-10P
in place on the collar (RRS logo should read in the
same direction as the Nikon logo).
4. Inspect Nikon nameplate on your lens to determine
if you own the VR-II or VR-I version of this lens, then
continue with corresponding instructions at right.
VERSION VR-II
5. Inspect the six replacement screws provided by Really
Right Stuff and select the four screws that are all the
same length. Use these screws to securely install
LCF-10P. Seat hex key firmly and use care to
prevent stripping hex socket head.
VERSION VR-I
5. Inspect the six replacement screws provided by Really
Right Stuff and select two of the longer screws and
two of the shorter screws.
6. Use the two longer screws to install the edge of the
LCF-10P that is closer to the front of the lens (above
the RRS logo).
7. Use shorter screws to install the edge of the LCF-10P
that is closer to the rear of the lens (below the RRS
logo). Seat hex key firmly and use care to prevent
stripping hex socket head.
VR-I nameplate is gold with black lettering and reads:
AF-S VR-NIKKOR 70-200mm 1:2.8G
VR-II nameplate is black with gold lettering and reads:
AF-S NIKKOR 70-200mm 1:2.8GII ED
Front of Lens
Rear of Lens