RRS MC-L User manual

MC-L MULTI-CAMERA
L-PLATE
MC-L TOP VIEW: MC-L BOTTOM VIEW:
SPECIFICATIONS:
Weight ........................................................................................ 3.2oz / 91g
Compatible with..................................most metal-bodied film cameras
Comes with ................. one each ¼”-20 mounting screw, 5/32” hex key
Install mounting screw
in any of the four slots;
slots are threaded at one
end. Install screw only at
threaded end of slot.
Accessory socket threaded
¼”-20.
Fit anti-twist flange snugly
against back of camera for a
“no twist” fit.
All edges are smoothly
radiused; no sharp
corners.
Dovetail grooves fit in
all Really Right Stuff
clamps.
Slots are threaded only at one end; move
screw to threaded end to remove or install.
1146 Farmhouse Lane, San Luis Obispo,
California 93401 USA
1-805-528-6321 | 1-888-777-5557
www.ReallyRightStu.com

INSTALL
Position Flange and Select a Slot
Before installing the screw in the plate, fit plate to bottom of camera
as shown below. There are four separate slots with screw threads at
one end of the slots in which you can insert the captive screw. Take
note of which screw slot most closely aligns with the camera’s tripod
socket when the MC-L is positioned as close as possible to the side
of the camera while still allowing access to any ports, switches or
latches needed to operate the camera after the MC-L plate is installed.
Install Captive Screw into Threaded Slot
After selecting a slot, use hex key to install screw. Screw it into the
threaded end of the slot; screw should freely slide in slot. Be sure not to
cross-thread the plate when removing or replacing the captive screw.
Loosely install screw into camera’s tripod socket and adjust plate so
flange is snug against rear of camera. Fully tighten screw.
REMOVAL
When removing the plate, take care to pull the plate away from the
body of the camera as the captive screw is being loosened. This
prevents the threads of the captive screw from damaging the slot or
threaded socket in the plate. If the screw needs to be removed from
the plate after it is removed from the camera, locate the screw at the
threaded end of the slot and carefully guide the screw threads into
female threads in the plate.
MAINTENANCE
General Care
Before installing plate, wipe off bottom of camera to prevent trapping
dirt or grit. When installing the mounting screw, note that slots are
threaded at only one end. Install screw first at the threaded
end, then it will slide easily in the slot for final positioning.
Periodically check mounting screw to make sure it is tightly installed.
Cleaning
Periodically wipe plate and quick-release clamp clean with a dry
cloth to remove any contamination.
GUARANTEE
ALL REALLY RIGHT STUFF BRAND PRODUCTS ARE GUARANTEED
TO THE ORIGINAL PURCHASER TO BE FREE OF DEFECTS IN
MATERIALS OR WORKMANSHIP FOR FIVE (5) YEARS FROM
THE DATE OF PURCHASE. PRODUCTS WILL BE REPAIRED OR
REPLACED AT OUR OPTION.
® , ™, © 2017 Really Right Stuff, LLC. All rights reserved.