Step 1
Insert both middle dividers (E) into the
bottom panel (B) and the top panel (A)
using (3) screws (G) per side. Ensure all
holes are facing the back of box.
Make sure panels are
well as in front to
ensure wood does not
split.
Make sure panels are
well as in front to
ensure wood does not
split.
Make sure panels are
well as in front to
ensure wood does not
split.
Make sure panels are
well as in front to
ensure wood does not
split.
NOTE: Wood does tend to have a natural bend in it when stored in packaging. If you experience
any spliting, don’t worry. We have provided extra pre-drilled holes as well as screws. It is not
necessary to use all three holes on each side.
When inserting the center divide for any of the following: Duplex, XL Duplex,
or Triplex: Slide Center Panel(s) through grooves to clear any possible debris that
Make sure panels are
well as in front to
ensure wood does not
split.
Step 2
Attach Top Panel (A) to both Side Panels (D) using (6) screws (G).
Attach Bottom Panel (B) to both Side Panels (D) using (6) screws (G).
NOTE: Top Panel (A) and Bottom Panel (B) front has no screw holes.
Front Panel (A), Bottom Panel (B), and Side Panel (D) will be
the front and not in the back.
Make sure panels are
well as in front to
ensure wood does not
split.
Step 3
Attach Back Panel (C) to both Side Panels (D) and Center
Panel (E) using (9) screws (G). Next, attach back panel (C) to
Top Panel (A) and Bottom Panel (B) using (8) screws (G).
Side View
Make sure panels are
well as in front to
ensure wood does not
split.
Side View
Make sure panels are
well as in front to
ensure wood does not
split.
Step 4
Attach Front Panel (F) to both Side Panels (D) and Center
Panel (E) using (7) screws (G).
When inserting the center divide for any of the following: Duplex, XL Duplex,
or Triplex: Slide Center Panel(s) through grooves to clear any possible debris that
Make sure panels are
well as in front to
ensure wood does not
split.
Make sure panels are
well as in front to
ensure wood does not
split.
Step 2
Attach Top Panel (A) to both Side Panels (D) using (6) screws (G).
Attach Bottom Panel (B) to both Side Panels (D) using (6) screws (G).
NOTE: Top Panel (A) and Bottom Panel (B) front has no screw holes.
Front Panel (A), Bottom Panel (B), and Side Panel (D) will be
the front and not in the back.
Make sure panels are
well as in front to
ensure wood does not
split.
Side View
ensure wood does not split.
Step 3
Attach Back Panel (C) to both Side Panels (D) and Center
Panels (E) using (12) screws (G). Next, attach back panel (C)
to Top Panel (A) and Bottom Panel (B) using (12) screws (G).
Step 4
Attach Front Panel (F) to both Side Panels (D) and Center
Panels (E) using (10) screws (G).
