Ryobi RLC18 User manual

RLC18

2
IMPORTANT!
It is essential that you read
the instructions in this manual
before assembling, operating,
and maintaining the product.
Subject to technical
modifications.
Safety, performance, and
dependability have been given
top priority in the design of your
area light.
INTENDED USE
The area light is intended for
general illumination. Do not use
the product in wet conditions.
Do not use the product for
any other purpose. Use of the
product for operations different
from intended could result in a
hazardous situation.
AREA LIGHT SAFETY
WARNINGS
■The light source of this
luminaire is not replaceable.
When the light source reaches
its end of life the whole
luminaire shall be replaced.
■Use only with recommended
battery pack and charger. Any
attempt to use another battery
pack will cause damage to the
product and could possibly
explode, cause a fire, or
personal injury.
■Do not disassemble the
product.
■If wrapped or in contact with
fabrics, the lens can produce
sufficient heat to melt some
fabrics. To avoid serious
personal injury, never allow
the lens to come in contact
with anything.
■Do not place the product or
battery pack near fire or heat.
This will reduce the risk of
explosion and possible injury.
■Remove the battery pack
before starting any work on the
product.
■Do not store the product
in a damp or wet location,
or in a location where the
temperature may reach or
exceed 40°C. For example,
inside sheds, vehicles, or
metal buildings in the summer.
BATTERY SAFETY
WARNINGS
■To reduce the risk of fire,
personal injury, and product
damage due to a short circuit,
never immerse your tool,
battery pack or charger in fluid
or allow a fluid to flow inside
them. Corrosive or conductive
fluids, such as seawater,
certain industrial chemicals,
and bleach or bleach-
containing products, etc., can
cause a short circuit.
TRANSPORTING LITHIUM BAT-
TERIES
Transport the battery in
accordance with local and
national provisions and
regulations.
Follow all special requirements
on packaging and labelling
when transporting batteries by
a third party. Ensure that no

3
batteries can come in contact
with other batteries or conductive
materials while in transport by
protecting exposed connectors
with insulating, non-conductive
caps or tape. Do not transport
batteries that are cracked
or leaking. Check with the
forwarding company for further
advice.
MAINTENANCE
■Use only original accessories
and spare parts. Should
components need to be
replaced which have not been
described, please contact an
authorised service centre. All
repairs should be performed
by an authorised service
centre.
■Avoid using solvents when
cleaning plastic parts. Most
plastics are susceptible to
various types of commercial
solvents and may be damaged
by their use. Use clean cloths
to remove dirt, carbon dust,
etc.
■Do not at any time let brake
fluids, gasoline, petroleum-
based products, penetrating
oils, etc., come in contact with
plastic parts. Chemicals can
damage, weaken or destroy
plastic which may result in
serious personal injury.
SYMBOLS ON THE
PRODUCT
Safety alert
V Volts
Direct current
Read the instructions
carefully before using
the product.
Regulatory
Compliance Mark
(RCM). Product meets
applicable regulatory
requirements.
Class III protection
Waste electrical
products should not
be disposed of with
household waste.
Please recycle where
facilities exist. Check
with your local authority
or retailer for recycling
advice.
SYMBOLS IN THIS MANUAL
Note
Parts or accessories
sold separately
Waiting time
Off

4
LED lens
Power button
Hanging bracket
Battery port
Operator’s
manual
Battery pack
Charger

5
100% 40% 10% 0%
2sec
1
2
1
2

6
2sec
10%
1
1
2

7
PRODUCT SPECIFICATIONS
Area light
Model RLC18
Voltage 18 V
Wattage 4 W
Light output (lumens)
High brightness level 400 Lm
Medium brightness level 200 Lm
Low brightness level 40 Lm
Colour rendering index (CRI) 80
Correlated colour temperature (CCT) 4000 K
Weight - excluding battery pack 0.2 kg
BATTERY AND CHARGER
Model Compatible battery
pack (not included)
Compatible charger
(not included)
Lithium-ion
RB18L13
RB18L15
RB18L15A
RB18L15B
RB18L20
RB18L20A
RB18L25
RB18L25A
RB18L40
RB18L40A
RB18L50
RB18L50A
RB18L60A
RB18L90A
BCS618G
BCL14181H
BCL14183H
BCL1418IV*
RC18150U
RC18627U
RC18120
RC18115
*for vehicles with 12V DC outlets

RYOBI is a trade mark of Ryobi Limited, and is used under license.
© 2021 Techtronic Cordless GP
20210429v1
Imported by:
Techtronic Industries Australia Pty Ltd
31 Gilby Road, Mount Waverley,
VIC, 3149, Australia
Techtronic Industries N.Z. Limited
Unit C, 70 Business Parade South,
Highbrook, Auckland 2013, New Zealand