SAFAVIEH COUTURE Damian SFV4755 User manual

CARE AND MAINTENANCE
NOTICE
Part List and Hardware List
SAFAVIEH
Spot clean using a mild water-free solvent. Only a professional cleaner should
undertake a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
* Please make sure that you have all parts indicated before you begin assembly of
this item
* This item should be assembled on a soft surface to prevent scratching the finish
during assembly
* This item may require periodic tightening
C O U T U R E
WARNING: DO NOT STAND ON BENCH
WARNING: DO NOT OVER TORQUE BOLTS/SCREWS
Dimensions: 53.1"WX20.9"DX20.9"H
Weight Capacity: 275lbs
SFV4755
The legs and hardware are located underneath the bench in the velcro
compartment
8X
B4X
8X
HW1 8X
PIECE DESCRIPTION PICTURE
QUANTITY
1X
A1X
Bench Body
Bench Leg
Flat Washer(M6)
Split Lock Washer (M6)
HW2
HW4
HW3 Socket Screws 6*1.05*35MM
Allen Key

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
If any partismissing or damaged, do not attempt to assemble the product.
Estimated Assembly Time:10minutes.
Tools Required for Assembly (included):
Allen Key
PREARATION
Assembl the slat legs"H" with part ofAssembl the slat legs"H" with part ofAssembl the slat legs"H" with part of Assembl the slat legs"H" with part of
Rotate the slat legs H to the middle rod of slat
G. Put it inside the middle of the bed, And
then, smooth the slat F inside the bed
Rotate the slat legs H to the middle rod of slat
G. Put it inside the middle of the bed, And
then, smooth the slat F inside the bed
STEP4 Rotate the slat legs H to the middle rod of slat
G. Put it inside the middle of the bed, And
then, smooth the slat F inside the bed
Rotate the slat legs H to the middle rod of slatRotate the slat legs H to the middle rod of slat STEP5
Secure the slat with screw HW1 by using
wrench HW6.There are totally 9 holes on slat
to make sure it stable, it's shown in step 4
The legs and hardware are located underneath the bench in the velcro
compartment.
and secure the slat with screw HW1 by using
wrench HW2.There are totally 9 holes on slat
to make sure it stable, it's shown in step 3.
Secure the sideboard with headboard with HW1
A
B
A
B
B
B
B
HW4
STEP5 PUT THE BENCH UPRIGHT AND MAKE SURE
ALL LEGS ARE LEVEL, THEN FIRMLY TIGHTEN
BOLTS WITH ALLEN KEY WHILE THE BENCH IS
UPRIGHT AS PICTURE ADOVE, THE BENCH IS
READY TO ENJOY NOW!
STEP1 OPEN THE VELCRO ON THE UNDERSIDE OF
THE SEAT AND TAKE OUT LEGS AND HARDWARE
STEP2 PUT THE WASHERS ON THE SCREW IN THE
ORDER SHOWN IN THE PICTURE
HW2 HW1 HW3
STEP3 INSERT THE LEGS AND SCREW IN THE SCREWS
BUT DON'T TIGHTEN COMPLETELY.
STEP4 CLOSE THE ZIPPER ON THE UNDERSIDE OF
THE SEAT
A