SAFAVIEH COUTURE KNT4092 User manual

CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should undertake
a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
NOTICE
*Please make sure that you have all parts indicated before you begin assembly of this item.
*This item should be assembled on a soft surface to prevent scratching the finish during assembly.
*This item may require periodic tightening.
Parts List and Hardware List Model# KNT4092
Product Dimensions: Queen: 67” W*88.75” D*58.5” H
PIECE DESCRIPTION PICTURE QUANTITY Carton Call King: 82.5” W*88.75” D*58.5” H
A Headboard 1x 1 of 2
B Footboard 1x 1 of 2
C Side rail 2x 2 of 2
D Slat support-short 5x 1 of 2
E Support Foot 5x 1 of 2
F Bed Leg set 4x 1 of 2
HW1 Threaded Rod 11.5cm 4x 1 of 2
HW2 Threaded Rod 11.5cm 4x 1 of 2
HW3 Curved Washers 8x 1 of 2
HW4 Lock Washer 8x 1 of 2
HW5 Nuts 8x 1 of 2
HW6 Spanner 1x 1 of 2
HW7 Screws 10x 1 of 2
HW8 Allen Head Bolt
（0.8cm Dia) 8x 1 of 2
HW9 Allen Key 1x 1 of 2
*** The hardwares are packed with the headbard

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assemble Time: 5 minutes.
12
Step 1 Step 2
1. Place Headboard (A) on a flat floor covered with a protective material to 1.Locate the support Foot (E) onto the slat support-short( D) as hsown in the
prevent damage to Headboard (A); diagram II;
2. Locate the bed legs(F) into the headboard (A)and Footboard(B) by Allen head bolt(HW8) , 2. Place the Slat Support-short (D) onto the slots of the side Rail (C);
tighten by allen key(HW9) as diagram II 3. Screw (HW7) the ends of the slated to the cleats on the Side Rail (C) as shown
3. Stand the Headboard (A) upright and Locate Side Rail (C) as shown in the in the Diagram III.
diagram I ;
4. Locate the Threaded Rods (HW1) into the holes on the end of Side Rail (C),
and Insert curved washers (HW3) ,Lock Washers (HW4),Nuts (HW5) onto the Threaded
Rods (HW1) to attach the Headboard (A) and attach the Side Rail (C) as shown in the diagram I;
5.Tighten the nuts (HW5) & Threaded Rods (HW1 ) with Spanner wrench (HW6) as shown in
the diagram I;
6. Use Threaded Robs(HW2),and Repeat the procedure with the Footboard (C).
F
A
CB
D
E
D
E
7
D
Diagram III Diagram IV
SIDE RAIL
7
9
Diagram II
Diagram I
SIDE
RAIL
HEADBOARD
&
FOOTBOARD
3
41
5
6
B
A
C
F
8
8
9
9