Safety Xpress BOLSM165 User manual

www.safetyxpress.com.au
PRODUCT INFORMATION &
INSTALLATION GUIDE
1300 049 246
Specications
SKU BOLSM165
Material Hot Dip Galvanised Steel
Colour
Powder Coated Yellow with
Class 1 Red Reective Tape
Black Plastic Cap on top
Dimensions:
Height: 1300mm
Diameter:
165mm (Pole) 300mm (Base)
Wall Thickness: 3mm
Base: 4 Mounting Holes
16mm each in Diameter
Item Weight 21kg
Fixings
4 x FREE Mounting Bolts
Included per bollard
(standard xings kit)
Surface Mount Bollard
Installation:
1. Read instruction steps from beginning to end.
2. Determine exactly where the bollard will
be placed. If you are installing more than one
bollard, it is a good idea to mark the ground to
ensure that you have a straight line to assist you
with the correct placement of your bollards.
3. Using your hammer drill, drill a guide hole in
the surface, through each hole in the bollard
using the drill bit. (This is to mark the surface so
that you know where to continue to drill).
Tools Required:
• Hammer drill with 14mm drill bit
• Fixing kit
• The correct sized socket
• A hammer
• A hand broom or industrial vacuum
4.Remove the bollard and brush or vacuum away
the dust.
5. Continue to drill each guide hole to almost the
entire length of your xings.
6. If you are using a plastic plug component, put it in
the drilled hole and hammer in.
7. Place the bollard over the holes, line up and place
your xing in the holes and screw or hammer in.
8. Use your socket to tighten the screw if applicable.
Be careful not to overtighten.
FREE
Fixings
Reective
2
2
MONTHS
MONTHS

www.safetyxpress.com.au
PRODUCT INFORMATION &
INSTALLATION GUIDE
1300 049 246
Technical Drawing
SKU: BOLSM165
Surface Mount Bollard
165mm x 1300mm
1300mm
10mm
Ø 165mm
3mm
wall
300mm
240mm