Salamander UNIFI User manual

Salamander Uni Meeting Table 1 of 4 501-750 [9.20]
UNIFI™ MEETING TABLE
Assembly Instruction
LIMITED WARRANTY FOR COMMERCIAL UNIFI MEETING TABLE
Salamander is proud to stand behind our products with industry-leading warranties. Should you ever encounter
any problem with your Salamander product, let us know. We are here to make it right. 1.860.761.9500
Full warranty including limitations and warranty claim information may be found at
www.salamandercommercial.com/warranty

Salamander Uni Meeting Table 2 of 4 501-750 [9.20]
A. First remove the Lift-O Panel. See gure 2 on page 4.
B. Slide the two halves together and make sure the front base surfaces are ush.
C. Insert two 1/4-20 x 2" joint connector bolts through the top holes and two bolts through the third hole
from the bottom. Secure the two table halves using the hex key.
1. JOINING PEDESTALS (IF APPLICABLE)
1/4-20 x 2" Joint
Connector Bolt

Salamander Uni Meeting Table 3 of 4 501-750 [9.20]
A. Assemble the Field Joint Kit using the wrench provided. The Threaded Block should be spaced approximately
3” away from the Unthreaded Block to be able to loosely t in the table’s Joint Pocket.
B. Insert the Joint Pocket Spline into the
Joint Pocket, as shown above.
C. Place the two table segments on top
of the base and push the two together
while aligning the Joint Pockets.
D. Install Joint Pocket Kits where
access is available. The table top will
have to be carefully moved to provide
access to some of the Joint Pockets.
Unthreaded
Block
1/4-20
Washer
1/4-20 x 3.5"
Shoulder Bolt
Threaded
Block Approximately
3"
Joint Pocket Spline
Joint Pocket
2. ASSEMBLE TOP (IF APPLICABLE)
FIELD JOINT KIT

Salamander Uni Meeting Table 4 of 4 501-750 [9.20]
Attach the Lift-Off Panel to the Pedestal Base by dropping the Lift-Off Brackets onto the
Shoulder Bolts, as shown in figure 2.
NOTE: If both panels are
locked then the top must be
removed to remove a panel.
Lift-up
and out
⏎
Lift-O
Panel
Panel Lock (If desired)
FIGURE 3
Table
Support
1/4-20 x 1"
Button Head
Socket Cap
Screws
FIGURE 1
Using the Hex Key provided, attach the table top to the pedestal base
using the 1/4-20 x 1” Button Head Socket Cap Screws, as shown in
figure 1 to complete the assembly.
Lift-O
Panel
Bracket
Shoulder Bolt
FIGURE 2
3. ATTACH TABLE TOP
4. LIFT-OFF PANEL
5. LEVEL TABLE
Adjust levelers as needed.