Santec 3465HO User manual

Installation Instruction
Paper Holder
Please read the instructions completely before beginning the installation.
Paper Holder
Rev 06/2016
INSTALLATION INSTRUCTIONS
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
1/4
WOODEN SURFACE
DRY WALL SURFACE
1- Take the trim parts off the box.
Place the trim parts against the assigned wall location.
Make sure that the roller is leveled and the roller post positions are correct.
Leave 5’ to 5-1/4” space between the roller posts for the rollers.
Mark the roller post flange positions and remove the trims.
2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the post flange mark on the wall.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting hardware posts can be secured by
screwing the screws directly into the wall.
2b- IF INSTALLING ON A DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Fold the toggle’s leg and insert it into the wall.
- The mounting hardware posts can be secured by screwing the screws
into the toggles.

The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
2/4
2c- IF INSTALLING ON A SOLID/HARD SURFACE
- Measure the dimension carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting hardware post by screwing the
screws into the wall.
HARD SURFACE
3- Using the Allen key provided, loosen the roller posts’ set screws.
Slip the left roller post with the washer onto the left mounting hardware post
Align the roller post and secure it by tightening the set screw.
Screw the hardware post adapter then, screw the post to the flange.
4- Insert the rollers with the spring onto the secured roller post.
Slip the right roller post with the washer onto the right mounting hardware post.
Insert the right side of the rollers into the right roller post.
Align the roller post and tighten the set screw firmly .
5- Check both roller posts to make sure they are firmly secured.
If not, tighten the set screws with the Allen key.
.