Santec LIZA 5161LZ75 User manual

E-SERIES SERIES
LIZA COLLECTION
24” TOWEL BAR
MODEL: 5161LZ
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
Important: Santec reserves the right to request additional documents before
servicing warranty requests.
01 02
Installation Instructions
Place the trim parts against the assigned wall location. Make sure the bar is leveled and the bar post
positions are correct. Mark with pencil the bar post ange positions and remove the trims.
1.
WALL
bar post
Using the Allen key provided, remove the holder post from the mounting post. Press the mounting post
against marked post position on the wall and mark the screw hole positions.
NOTE: MAKE SURE THE ALLEN SCREW HOLE ON THE MOUNTING POST IS FACING DOWN
WHEN SECURING TO WALL.
INSTALLING ON WOODEN SURFACE
For wooden surface, the mounting post can be
secured by screwing the screws directly into the wall.
INSTALLING ONTO DRYWALL SURFACE
Using a drill, pre-drill holes for the anchors. Insert the
anchors into the wall. The mounting post can be
secured by screwing the screws into the anchors.
INSTALLING ONTO A SOLID SURFACE
Measure the dimensions carefully. Using a drill,
pre-drill the holes. Secure the mounting post by
screwing the screws into the wall.
2.
holder post mark
mounting post

03
Installation Instructions
Press the holder post over the mounting post. Align the holder and secure it by tightening the set
screw.
3.
4. Check the holder post to make sure it is rmly secured. If not, tighten the set screw with the Allen key.