Santec HANA 4164TR Series User manual

PAGE 01
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
HAND TOWEL BAR
MOUNTING SCREWS (2)
DRY WALLANCHORS(2)
ALLEN KEY
SET SCREW
MOUNTING SCREW PLATE
INSPECTED BY
4164TR_ _
MODEL NUMBER
DESIGNER SERIES HANACOLLECTION
HAND TOWEL BAR

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the hand towel bar out of the box.
Place the trim parts against the assigned wall location.
Make sure that the bar is leveled and pointed to the
right.
Mark the post position and remove the trim.
2- Using the Allen key provided, remove the mounting screw plates from the
ring posts.
Press the mounting screw plate against ring post position on the
wall and mark the screw hole positions.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting screw plates can be secured by
screwing the screws directly into the wall.
2b- INSTALLING ON A DRYWALL
- Using a drill, pre-drill holes for the anchors.
- Insert the anchors into the wall.
- The mounting screw plate can be secured by screwing the screws
into the anchors.
2c- IF INSTALLING ON A SOLID/HARD SURFACE
- Measure the dimensions carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting screw plate by screwing the screws into
the wall.
3- Press the post against the mounting screw plate. Align the
post and secure it by tightening the set screw.
4- Check the post to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: [phone] Fax [phone]
www.santecfaucet.com 07/04
WALL
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
post flange mark
mounting screw plate
4164TH _ _
pointing right