SCHEIBER SA - 85120 SAINT PIERRE DU CHEMIN - FRANCE
Tel : 02 51 51 73 21 Fax : 02 51 51 75 03 edition 01/97
Tel intern.: 33 2 51 51 73 21 Fax intern.: 33 2 51 51 75 03
CHARGER IN BIP BOX 10 A with fuses Ref 30.63351.81
This charger, approved CE, is made according to the EN 60-742 and EN 60335-2-29 norms.
Characteristics :
PARTICULARITIÉS :
This model of charger do not supply any current, nor gives any voltage to its terminal as long as it is
not connected to a battery whose voltage is minimum 8V. This charging system enables lo let the
vehicle permanently connected to 230V supplying source. But you have to check regularly batteries’
level of electrolyt. In fact, the chemical phenomenon generated by the charge entails water
consumption more or less important according to batteries’ state and technology.
BE CAREFUL :
- the connection of the input terminal "ground"is COMPLUSORY in order that, in case of bad
insulation of one of the equipments connected on BIP 230V, people remains continuously protected
by the differential of the plug on which the vehicle is connected (use the terminal given in
accessory).
- when wiring is changed and cable-grips cutted, once new wiring is finished you must
NECESSARY replaced cable-grips.
- when changing an output fuse, please respect the calibers given above.
WARNINGS :
-during the battery recharge, explosive gas are given. Avoid flames and sparks near the battery.
-disconnect the supply of the charger before connecting or disconnecting the battery plugs.
-do not try to charge cell or any other non-rechargeable battery.
