Screen Innovations 5 Series Curved Fixed User manual

INSTALLERS: PLEASE BE SURE TO LEAVE THIS
MANUAL WITH THE OWNER. THANK YOU!
CURVED FIXED
5 SERIES
Owner’s Manual

Screen Innovations warrants its products, to the original purchaser only, to be free from defects in
materials and workmanship for a period of one (1) year from the date of purchase by the original
purchaser provided they are properly operated according to Screen Innovations’ instructions
and are not damaged due to improper handling or treatment after shipment from the factory.
This warranty does not apply to equipment showing evidence of misuse, abuse, or accidental
damage, or which has been tampered with or repaired by a person other than authorized Screen
Innovations personnel.
Screen Innovations’ sole obligation under this warranty shall be to repair or to replace (at Screen
Innovations’ option) the defective part of the merchandise. Returns for service should be made
to your Screen Innovations’ dealer. If it is necessary for the dealer to return the screen or part to
Screen Innovations, transportation expenses to and from Screen Innovations are payable by the
purchaser and Screen Innovations is not responsible for damage in shipment. To protect yourself
against damage or loss in transit, insure the product and prepay all transportation expenses.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
WARRANTIES AS TO FITNESS FOR USE AND MERCHANT ABILITY. Any implied warranties of
tness for use, or merchantability, that may be mandated by statute or rule of law are limited to
the one (1) year warranty period. This warranty gives you specic legal rights, and you may also
have other rights, which vary from state-to-state. NO LIABILITY IS ASSUMED FOR EXPENSES
OR DAMAGES RESULTING FROM INTERRUPTION IN OPERATION OF EQUIPMENT, OR FOR
INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.
In the event that there is a defect in materials or workmanship of a Screen Innovations product,
you may contact our Sales Partners at 9715-B Burnet Road Suite 400, Austin, TX 78758, (512)
832-6939.
IMPORTANT: THIS WARRANTY SHALL NOT BE VALID AND SCREEN INNOVATIONS SHALL NOT
BE BOUND BY THIS WARRANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH
SCREEN INNOVATIONS’ WRITTEN INSTRUCTIONS.
Keep your sales receipt to prove the date of purchase and your original ownership.
LIMITED ONE YEAR WARRANTY
ON SCREEN INNOVATIONS PRODUCTS
APPLY S/N
STICKER HERE

5 SERIES FIXED
3
0316165F
?
512-832-6939
SCREENINNOVATIONS.COM
9715-B Burnet Road Suite 400, Austin,TX 78758

5 SERIES FIXED
4
Projector Placement
11°
11°
SCREEN
Better
Best
Good
36”-42”
(91cm - 106cm)

5 SERIES FIXED
5
0316165F
611
CURVED CURVED  SPLIT

6
CURVED
2X
1X
2X
1X
Hardware Kit
8X
4X
(MAESTRO ONLY)
Frame Installation

7
0316165F
CURVED

8
CURVED
1
2

9
0316165F
CURVED
4
3
Set screws should be nger tightened
only at this point

10
CURVED
17
A = B
5
6
A B
Square the frame using a carpenters square or tape
measure. Tighten the set screws using the provided
allen tool. DO NOT use an impact or drill to tighten
the set screws as it will damage the frame.

11
0316165F
CURVED - SPLIT
2X
1X
2X
1X
Hardware Kit
8X
4X
4X
(MAESTRO ONLY)
Frame Installation
4X
Larger screens are shipped with slot nuts, bolts,
and vertical support bars. These must be installed
on large, split frame screens, or wall brackets must
be installed top and bottom.

12
CURVED - SPLIT

13
0316165F
CURVED - SPLIT
1
2
Install the t-slot nuts in the horizontal frame pieces be-
fore putting the corner brackets in.

14
CURVED - SPLIT
4
3
Set screws should be nger tightened
only at this point

15
0316165F
CURVED - SPLIT
5 6
Tighten the set screws with the supplied allen wrench. DO NOT
use a drill or impact, as this will damage the frame.

16
CURVED - SPLIT
A = B
AB
7
8
Square the frame using a carpenters square or tape
measure. Tighten the set screws using the provided
allen tool. DO NOT use an impact or drill to tighten
the set screws as it will damage the frame.

5 SERIES FIXED
17
0316165F
Material?
SLATE & PURE
MAESTRO
18
20

SLATE/PURE
18
1
2
Material Installation

SLATE/PURE
19
0316165F
4
5
1.
22
4.
2.
3.
Starting in the middle of each horizontal and vertical, snap/bungee
the middle of each side, then work your way outward, completing a
side at a time.

MAESTRO
20
1
2
Material Installation
Insert the tensioning rods
into the pockets as shown.
Maestro material has a black backer that must be installed
with the viewing material to eliminate shine through.