IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
© Jack Sealey Limited Original Language Version
INSTRUCTIONS FOR:
FRONT AXLE UPPER BALL JOINT
EXTRACTOR/INSTALLER - VW T4
MODEL NO: VSE725.V2
1. SAFETY
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
Maintain the tool components in good and clean condition for best and safest performance.
Ensure that a vehicle which has been jacked up is adequately supported with axle stands.
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey stockist.
Wear suitable clothing to avoid snagging. DO NOT wear jewellery and tie back long hair.
Keep children and other unauthorised persons away from the working area.
Ensure there is adequate lighting prior to using the ball joint replacement tool.
DO NOT use the kit if any parts are missing or damaged.
DO NOT use the ball joint replacement tool for any purpose other than that for which it is designed.
IMPORTANT: These instructions are intended as a guide only. Always refer to the vehicle manufacturer’s service instructions or a proprietary
manual to establish the current procedure.
2. INTRODUCTION
3. APPLICATIONS
4. CONTENTS
5. OPERATION
Suitable for removing and installing the upper front ball joint on-vehicle
without the need to disassemble. Features a variety of adaptors used in
different combinations for extracting and installing, see below. Supplied in
a carry-case with each part numbered for simple selection.
Model No: ....................................VSE725.V2
Applications: ......................VW: T4 2000cc, T4 2500cc
Clean and lubricate the thrust screw with grease before use
VS725.V2 Issue: 1 21/07/16
Wear eye
protection
Refer to instruction
manual
