Seametrics iMAG 4700 User manual

iMAG 4700
Mechanical Quick Start Guide
253.872.0284 seametrics.com
ComponentsComponents
Power/Output Cable
(DC conguration)
OptionalOptional
Output Cable
(Battery
conguration)
Security Seal
Recommended ToolsRecommended Tools
Recommended:
• T-15 Torx head driver
• 0.098 inch (small) at head screw driver
• Crescent Wrench
Optional:
• Channel locks
Meter and
Indicator with
Hinged Cover
ANSI/NSF-61
Rated Gaskets
Gaskets
Failure to install
gaskets will void
warranty!

LT-14687r1.0 20201116
11/16/2020
iMAG 4700
Mechanical Quick Start Guide
Seametrics • 19026 72nd Avenue South • Kent, Washington 98032 • USA
(P) 253.872.0284 • (F) 253.872.0285 • 1.800.975.8153 • seametrics.com
GroundingGrounding
Metal Pipe Plastic Pipe
Choose a position that will ensure a full pipe. Choose a position that will minimize ow distortion.
5X 1X
2X 1X
5X 1X
PositioningPositioning
Not Ideal:
Air bubbles and
sediment on the
electrodes can aect
accuracy
Recommended:
Improved accuracy
results from
unimpeded electrodes Electrode moved from
top by rotating meter
Intermittent air
bubbles miss electrode
Electrodes free from
sediment build-up
Intermittent air
bubbles pass
over electrode
Possible
sediment
build-up
Refer to the Electrical Quick Start Guide or the complete instruction manual for details on wiring.
Equalization Lug
Ground Clamp
(Exothermically weld when
corrosion is a concern)
8’ Ground Rod
Earth
Grounding Ring
Gaskets
Grounding Ring
Gaskets
#6, #8, or #12 AWG Stranded
Copper Ground Wire < 5’
Plastic
Pipe
Plastic
Pipe
Equalization Lug
Meter
Flange Pipe
Flange
Gasket
Pipe Flange
Flange Plate
Lockwasher
Metal Pipe
Metal Pipe
Meter Flange
Gaskets
WarningsWarnings
• Do not weld or ame cut within 10’ of meter. Heat will
damage electronics and liner. (Heat will void warranty.)
• Install provided full face gaskets. Failure to install gaskets
will void warranty.
• Tube must be completely aligned with adjoining anges.
• Ensure proper grounding.
• Bolts must be tightened evenly. Do not over tighten one side
to ll a gap.
• Install security seal during installation if regulations require.
• Backup batteries are not intended as a primary power source.
Refer to instruction manual for further details.