SEI WS9818 User manual

Page 1
Assembly Instruction
Mirrored Wall Sculpture

Page 2
Mirrored Wall Sculpture
Parts List
Please check packaging for all parts and hardware before discarding. Unpack and lay parts on clean, padded
surface like carpet or blanket. Check that you have all parts indicated. Call customer service if hardware is
missing. Before beginning assembly, carefully study the diagrams below and sort your hardware according to
the pictures. Using the incorrect hardware will cause damage.
A Quantity
of 1
Mirrored Wall Sculpture
1 Quantity
of 4
Plastic Anchor
2 Quantity
of 4
Screw
Care and Cleaning Instructions:
Before using, wipe with a clean, dry cloth.
Periodically apply furniture wax to renew
the finish. Avoid rubbing or scratching the
surface with rough or abrasive objects.
Assembly Tool Required
No.2 Phillips Screwdriver
Not Included
Tool List: 3/16" drill bit, drill, tape measure and pencil.

Page 3
Mirrored Wall Sculpture
Assembly Instructions
Note: Drilled hole or plastic anchor not required when mounting to
stud, use screw only. We do not supply hardware for mounting on
concrete walls.
Figure 1
Figure 2
Install Mirrored Wall Sculpture (A)
onto the Screws (2) and make sure
the bracket is resting securely on the
mounting screw (2).
Now your new Mirrored Wall
Sculpture is ready to use.
"The hole measurements on
the wall must match with the
hole measurements on back
of the unit"
Find a desired location and mark two
locations for screws on the wall.
One screw (for each unit) must be
attached directly into a wall stud.Wall
anchor is not needed when mounting
to wall stud.
Drill one of the markings with a 3/16"
drill bit (for each unit).
Insert plastic anchor (1) into the hole
on wall as shown, you will need a
hammer to lightly tap in the wall
anchors.
Using a Phillips head screwdriver,
install Screw (2) into the Anchor (1).
Turn the Screw (2) until there is a gap
of approximately 3mm between the
head of the screw and the wall as
shown.

Page 4
If you prefer to hang this product horizontally, please follow instructions below.
Note: Drilled hole or plastic anchor not required when mounting to
stud, use screw only. We do not supply hardware for mounting on
concrete walls.
Figure 3
Find a desired location and mark two
locations for screws on the wall.
One screw (for each unit) must be
attached directly into a wall stud.Wall
anchor is not needed when mounting
to wall stud.
Drill one of the markings with a 3/16"
drill bit (for each unit).
Insert plastic anchors (1) into the hole
on wall as shown, you will need a
hammer to lightly tap in the wall
anchors.
Using the Phillips head screwdriver,
install screw (2) into the anchor (1).
Turn the screw (2) until there is a gap
of approximately 3mm between the
head of the screw and the wall as
shown.
Figure
4
Install Mirrored Wall Sculpture (A)
onto the screw (2) and secure the
bracket is resting securely on the
mounting screw (2).
Now your new Mirrored Wall
Sculpture is ready to use.
"The hole measurements on
the wall must match with the
hole measurements on back
of the unit"

Page 5
Customer Information
Name
Address
City/State/Zip Code
Phone Number
Please indicate where you purchased this item: Store/Website/Catalog
Please indicate color/size/style number:
Style No Parts Letter Parts Description Quantity Needed
Parts Replacement Form