Sensio Luce User manual

LUCE - SLS LED
PLINTH LIGHT KIT
CODE: 06.1110.0110
Components
Important safety information
Safety instructions
Tools required
INSTALLATION
INSTRUCTIONS
IMPORTANT: please read these instructions before commencing installation and retain for future reference.
Please read these instructions carefully before attempting to install
this product. It is advisable to keep these instructions in a safe place
for further reference.
We recommend that you consult a qualified electrician. All
electrical installations must be carried out in accordance with
current IEE wiring regulations (BS7671).
These products must not be modified, if any modifications are
made, it may invalidate the warranty and may render the product
unsafe. These LED lights operate low voltage (12V).
Do not wire the individual LED light fittings directly to the mains.
This product is for indoor use only.
• If in doubt installation must be carried out by a qualified
electrician.
• Install on smooth flat surface(s) only.
• Do not exceed or stretch the cable length of each LED wire.
• This product is IP44 Rated
•Each fitting runs at 0.18W. The driver in this pack has a maximum
allowance of 4W.
1. Before commencing installation or maintenance, isolate the main
electrical supply for the appropriate circuit at the fuse board.
2. This product is only suitable for connecting to a 240V 50Hz supply.
The light should be mounted onto a secure surface.
3.
Never exceed the total output of the LED driver (4W).
4. Suitable for furniture lighting.
5. When the lamp expires the fitting must be replaced.
6. Class III safety extra low voltage (SELV)
7. A maximum of 22 fittings can be run from the driver in this pack.
Waste Electrical & Electronic Equipment (WEEE)
The Symbol on the product, or on the document accompanying the product, the crossed out
wheelie bin symbol, indicated that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collection point for the recycling of electrical and
electronic waste.
44mm Screw Bit Power Drill1x 13A Plug Driver and LED
cable connector
4 x LUCE LED Lights 1 x Fitting Instructions

Installation instructions
Maintenance & Care
• Ensure that the power is disconnected prior to cleaning.
• To keep the finish of this product, wipe over with soft cloth periodically.
• Do not use harsh chemical solvents, it may dis-colour or damage the finish.
Unit 7 Speedwell Road, Whitwood, Castleford, West Yorkshire, WF10 5PY
www.sensio.co.uk
Technical drawings for illustration purposes only, Sensio has the right to change any information
without prior notice. Make sure you check all hole cut outs before work commences.
4
5
1
LUCE - SLS LED PLINTH LIGHT KIT
CODE: 06.1110.0110
These fittings simply daisy chain
together, each have a length of
pre-wired cable containing a plug on
the end, allowing each fitting to be
co-joined with another fitting.
The plug on the last fitting will then
simply be connected to the plug wired
onto the end of the transformer cable.
Allowing the pre-wired fittings to be
connected straight to a plug socket.
We recommend that you consult a
qualified electrician.
Maximum 22 x 0.18W LED fittings
per LED 4W driver.
Cut out four 44mm holes in the
plinth at your required locations.
23
Feed the wire from the first fitting through the cut out
hole, peel off the two self adhesive pads on the back of
each fitting then simply slot into place.
In turn connect each fitting to the previous,
via the connection plugs on the end of each
fitting.
The plug on the end of the last
fitting will then connect to the
transformer, which is pre-wired
ready to plug straight to a plug
socket or extension cable.