Seville Classics 05813 Installation guide

Step 7:
Fasten a pair of slip sleeves at the top of each
pole and slide the Top Shelf (I) over the poles
until secure.
Step 8:
Repeat steps 1-7 to assemble the second
tower.
Note: Make sure both sets of rod brackets are
installed at the same height on both towers.
Step 9:
Place the U-Sleeves (H) in the center of each
rod bracket. Install the Expandable Rod (J) by
inserting the Screws (for rod) (G) through the
u-sleeves on both ends of each rod. Tighten the
screws on both ends of each expandable rod
with a Phillips screwdriver. Place Shelf Liners
(K) on the small shelves.
Weight Capacity:
100 lbs per shelf
125 lbs on expandable rod (not extended)
50 lbs on expandable rod (extended)
TF120919
Expandable Closet Organizer
Model No. 05813
Assembly Instructions
Customer Service
Tel [phone]
Tel [phone]
Fax [phone]
Monday - Friday 8:30am to 4:30pm PST
Seville Classics, Inc.
Torrance, CA 90501 USA
www.sevilleclassics.com
Please read and save these instructions
© 2012 Seville Classics, Inc.

Step 1:
Screw the Leveling Feet (D) into 4 Bottom
Poles (B).
Step 2:
On the bottom of each pole, fasten a pair of
Slip Sleeves (C) around the grooves at the
desired shelf height.
Step 3:
Slide a Small Shelf (E) over the top of 4
bottom poles until it rests snugly over the slip
sleeves. Repeat steps 2 and 3 by attaching
slip sleeves and another small shelf at the
desired height.
Tip: It is easier to do this step with the unit on
its side. If necessary, use a rubber mallet to
further secure the shelf.
Step 4:
Once the unit is stable and upright, screw 4
Top Poles (A) into the bottom poles.
Step 5:
Determine the desired height to install the Rod
Bracket (F). Fasten a pair of slip sleeves
around the grooves on two poles and slide the
rod bracket over the two poles.
Step 6:
Install the 3rd and 4th small shelf at the
desired height. Repeat step 5 to add another
rod bracket.
Note: Leave enough room above the rod
bracket to install the Top Shelf (I).
2 pcs
Top Shelves
2 pcs
Expandable Rod
8 pcs
Shelf Liners
IJKAssembly Tools
Required
Phillips Screwdriver
8 pcs
Small Shelves
4 pcs
Rod Bracket
4 pcs
Screws (for rod)
4 pcs
U-Sleeve
EFG H
8 pcs
Top Poles
8 pcs
Bottom Poles
48 pairs
Slip Sleeves
8 pcs
Leveling Feet
ABC D
Plastic cap (top)
Threaded (bottom)
Please make sure you have all the parts before starting assembly.